Messages in this thread Patch in this message | | | From | Krzysztof Kozlowski <> | Subject | [PATCH v2 1/3] arm64: dts: qcom: sc7180-trogdor-homestar: fully configure secondary I2S pins | Date | Thu, 13 Oct 2022 14:46:58 -0400 |
| |
The Trogdor Homestar DTSI adds additional GPIO52 pin to secondary I2S pins ("sec_mi2s_active") and configures it to "mi2s_1" function.
The Trogdor DTSI (which is included by Homestar) configures drive strength and bias for all "sec_mi2s_active" pins, thus the intention was to apply this configuration also to GPIO52 on Homestar.
Reported-by: Doug Anderson <dianders@chromium.org> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
---
Changes since v1: 1. New patch
Not tested on hardware.
Cc: Doug Anderson <dianders@chromium.org> --- arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi index 1bd6c7dcd9e9..bfab67f4a7c9 100644 --- a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi +++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi @@ -194,6 +194,12 @@ pinmux { pins = "gpio49", "gpio50", "gpio51", "gpio52"; function = "mi2s_1"; }; + + pinconf { + pins = "gpio49", "gpio50", "gpio51", "gpio52"; + drive-strength = <2>; + bias-pull-down; + }; }; &ts_reset_l { -- 2.34.1
| |