lkml.org 
[lkml]   [2022]   [Oct]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH V3 00/21] Enhancements to pcie-tegra194 driver
Date
This patch series contains enhancements to the pcie-tegra194.c driver
that works for both Tegra194 and Tegra234 SoCs and for both RootPort
and Endpoint modes.

This patch series depends on the following series in the same order

PCI: designware-ep: Fix DBI access before core init
https://patchwork.ozlabs.org/project/linux-pci/list/?series=322681

PCI: endpoint: Rework the EPC to EPF notification
https://patchwork.kernel.org/project/linux-pci/list/?series=683493

Add DeInit support in the PCIe Endpoint framework
https://patchwork.kernel.org/project/linux-pci/list/?series=685157

V3:
* Addressed review comments from Bjorn
* Added new patches to the series

V2:
* Addressed review comments from test bot and Vinod

Vidya Sagar (21):
PCI: tegra194: Use devm_gpiod_get_optional() to parse
"nvidia,refclk-select"
PCI: tegra194: Drive CLKREQ signal low explicitly
PCI: tegra194: Fix polling delay for L2 state
PCI: tegra194: Handle errors in BPMP response
PCI: tegra194: Apply pinctrl settings for both PCIe RP and EP
PCI: tegra194: Refactor LTSSM state polling on surprise down
PCI: tegra194: Disable direct speed change for EP
phy: tegra: p2u: Set ENABLE_L2_EXIT_RATE_CHANGE in calibration
PCI: tegra194: Calibrate P2U for endpoint mode
PCI: tegra194: Free resources during controller deinitialization
PCI: tegra194: Remove IRQF_ONESHOT flag during Endpoint interrupt
registration
PCI: tegra194: Enable DMA interrupt
PCI: tegra194: Enable hardware hot reset mode in Endpoint
PCI: tegra194: Allow system suspend when the Endpoint link is not up
PCI: tegra194: Disable L1.2 capability of Tegra234 EP
PCI: tegra194: Set LTR message request before PCIe link up
PCI: tegra194: Reduce AXI slave timeout value
PCI: tegra194: Don't force the device into the D0 state before L2
PCI: tegra194: Free up EP resources during remove()
dt-bindings: PCI: tegra194: Add monitor clock support
PCI: tegra194: Add core monitor clock support

.../bindings/pci/nvidia,tegra194-pcie-ep.yaml | 6 +-
.../bindings/pci/nvidia,tegra194-pcie.yaml | 6 +-
drivers/pci/controller/dwc/pcie-tegra194.c | 261 ++++++++++++------
drivers/phy/tegra/phy-tegra194-p2u.c | 14 +
4 files changed, 194 insertions(+), 93 deletions(-)

--
2.17.1

\
 
 \ /
  Last update: 2022-10-13 20:47    [W:0.117 / U:0.656 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site