lkml.org 
[lkml]   [2022]   [Oct]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v10, 2/4] mailbox: mtk-cmdq: add gce software ddr enable private data
Date
if gce work control by software, we need set software enable
for MT8186 Soc

there is a handshake flow between gce and ddr hardware,
if not set ddr enable flag of gce, ddr will fall into idle
mode, then gce instructions will not process done.
we need set this flag of gce to tell ddr when gce is idle or busy
controlled by software flow.

0x48[2:0] means control by software
0x48[18:16] means ddr enable
0x48[2:0] is pre-condition of 0x48[18:16].
if we want set 0x48[18:16] ddr enable, 0x48[2:0] must be set at same
time.
and only these bits is useful, other bits is useless bits

Signed-off-by: Yongqiang Niu <yongqiang.niu@mediatek.com>
---
drivers/mailbox/mtk-cmdq-mailbox.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/drivers/mailbox/mtk-cmdq-mailbox.c b/drivers/mailbox/mtk-cmdq-mailbox.c
index c3cb24f51699..d2363c6b8b7a 100644
--- a/drivers/mailbox/mtk-cmdq-mailbox.c
+++ b/drivers/mailbox/mtk-cmdq-mailbox.c
@@ -39,6 +39,7 @@

#define GCE_GCTL_VALUE 0x48
#define GCE_CTRL_BY_SW GENMASK(2, 0)
+#define GCE_DDR_EN GENMASK(18, 16)

#define CMDQ_THR_ACTIVE_SLOT_CYCLES 0x3200
#define CMDQ_THR_ENABLED 0x1
@@ -81,6 +82,7 @@ struct cmdq {
bool suspended;
u8 shift_pa;
bool control_by_sw;
+ bool sw_ddr_en;
u32 gce_num;
};

@@ -88,6 +90,7 @@ struct gce_plat {
u32 thread_nr;
u8 shift;
bool control_by_sw;
+ bool sw_ddr_en;
u32 gce_num;
};

@@ -127,10 +130,16 @@ static void cmdq_thread_resume(struct cmdq_thread *thread)
static void cmdq_init(struct cmdq *cmdq)
{
int i;
+ u32 gctl_regval = 0;

WARN_ON(clk_bulk_enable(cmdq->gce_num, cmdq->clocks));
if (cmdq->control_by_sw)
- writel(GCE_CTRL_BY_SW, cmdq->base + GCE_GCTL_VALUE);
+ gctl_regval = GCE_CTRL_BY_SW;
+ if (cmdq->sw_ddr_en)
+ gctl_regval |= GCE_DDR_EN;
+
+ if (gctl_regval)
+ writel(gctl_regval, cmdq->base + GCE_GCTL_VALUE);

writel(CMDQ_THR_ACTIVE_SLOT_CYCLES, cmdq->base + CMDQ_THR_SLOT_CYCLES);
for (i = 0; i <= CMDQ_MAX_EVENT; i++)
@@ -545,6 +554,7 @@ static int cmdq_probe(struct platform_device *pdev)
cmdq->thread_nr = plat_data->thread_nr;
cmdq->shift_pa = plat_data->shift;
cmdq->control_by_sw = plat_data->control_by_sw;
+ cmdq->sw_ddr_en = plat_data->sw_ddr_en;
cmdq->gce_num = plat_data->gce_num;
cmdq->irq_mask = GENMASK(cmdq->thread_nr - 1, 0);
err = devm_request_irq(dev, cmdq->irq, cmdq_irq_handler, IRQF_SHARED,
--
2.25.1
\
 
 \ /
  Last update: 2022-10-10 13:32    [W:0.068 / U:1.524 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site