lkml.org 
[lkml]   [2022]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    /
    From
    Date
    SubjectRe: [PATCH v4 1/6] media: i2c: ov5640: Remain in power down for DVP mode unless streaming
    On Tue, Jan 4, 2022 at 9:57 AM Lad, Prabhakar
    <prabhakar.csengg@gmail.com> wrote:
    >
    > Hi Eugen,
    >
    > On Mon, Jan 3, 2022 at 11:29 AM <Eugen.Hristev@microchip.com> wrote:
    > >
    > > On 12/21/21 5:11 PM, Lad, Prabhakar wrote:
    > > > Hi Eugen,
    > > >
    <snip>
    > > > could you give it a shot with yavta please.
    > >
    > > Hello Lad,
    > >
    > > I debugged this further, and I have some news:
    > >
    > > It looks like the 'write 0x2 to SYS_CLTR0' does not fail itself, rather
    > > the sensor refuses to accept a power up.
    > >
    > > I tried to read the register before the write, and it reads 0x42.
    > > Then, I tried to write 0x42 back, and it works fine.
    > > So, I do not think there is a problem with i2c communication.
    > > The only problem is that the sensor refuses to power up (accept the 0x2
    > > into the SYS_CTRL_0 ), due to an unknown (to me) reason.
    > >
    > That's strange.
    >
    > > If the power up is performed at the initialization phase, it works.
    > >
    > > I also tried to capture with v4l2-ctl, and the result is the same.
    > >
    > you mean yavta ?
    >
    > > Which of the init configuration set of registers your test is using?
    > I have been testing 320x240 and 640x480. Could you give that a try please?
    >
    > > It may be that it does not work in a specific config .
    > >
    > > The datasheet which I have does not claim that the 'power up' might fail
    > > in some circumstances.
    > >
    > Let me check if I can ping OmniVision FAE.
    >
    Fyi.. I got the below feedback from OmniVision FAE.

    SW standby bit is working as expected from my side.


    As far as the sensor initialization is concerned we use HW power up
    sequence defined in the datasheet followed by SW initialization.

    SW initialization consist of the following :-

    78 3103 11 ; I2C timing ( do not modify)
    78 3008 82 ; SW reset
    78 3008 42 ; Stop streaming
    78 ……. Sensor settings for required mode

    78 3008 02 ; Start streaming

    Note:- 0x3008[7] SW reset bit is volatile, as soon as a reset is
    applied the all the bits are cleared and 0x3008[7:0] set to
    default value hence should read 0x2

    Cheers,
    Prabhakar

    \
     
     \ /
      Last update: 2022-01-07 16:50    [W:3.545 / U:0.768 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site