lkml.org 
[lkml]   [2022]   [Jan]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH net v2] net: phy: Fix qca8081 with speeds lower than 2.5Gb/s
A typo in qca808x_read_status means we try to set SMII mode on the port
rather than SGMII when the link speed is not 2.5Gb/s. This results in no
traffic due to the mismatch in configuration between the phy and the
mac.

v2:
Only change interface mode when the link is up

Fixes: 79c7bc0521545 ("net: phy: add qca8081 read_status")
Cc: stable@vger.kernel.org
Signed-off-by: Jonathan McDowell <noodles@earth.li>
---
drivers/net/phy/at803x.c | 26 +++++++++++++-------------
1 file changed, 13 insertions(+), 13 deletions(-)

diff --git a/drivers/net/phy/at803x.c b/drivers/net/phy/at803x.c
index 5b6c0d120e09..29aa811af430 100644
--- a/drivers/net/phy/at803x.c
+++ b/drivers/net/phy/at803x.c
@@ -1688,19 +1688,19 @@ static int qca808x_read_status(struct phy_device *phydev)
if (ret < 0)
return ret;

- if (phydev->link && phydev->speed == SPEED_2500)
- phydev->interface = PHY_INTERFACE_MODE_2500BASEX;
- else
- phydev->interface = PHY_INTERFACE_MODE_SMII;
-
- /* generate seed as a lower random value to make PHY linked as SLAVE easily,
- * except for master/slave configuration fault detected.
- * the reason for not putting this code into the function link_change_notify is
- * the corner case where the link partner is also the qca8081 PHY and the seed
- * value is configured as the same value, the link can't be up and no link change
- * occurs.
- */
- if (!phydev->link) {
+ if (phydev->link) {
+ if (phydev->speed == SPEED_2500)
+ phydev->interface = PHY_INTERFACE_MODE_2500BASEX;
+ else
+ phydev->interface = PHY_INTERFACE_MODE_SGMII;
+ } else {
+ /* generate seed as a lower random value to make PHY linked as SLAVE easily,
+ * except for master/slave configuration fault detected.
+ * the reason for not putting this code into the function link_change_notify is
+ * the corner case where the link partner is also the qca8081 PHY and the seed
+ * value is configured as the same value, the link can't be up and no link change
+ * occurs.
+ */
if (phydev->master_slave_state == MASTER_SLAVE_STATE_ERR) {
qca808x_phy_ms_seed_enable(phydev, false);
} else {
--
2.30.2
\
 
 \ /
  Last update: 2022-01-31 14:57    [W:0.056 / U:0.764 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site