lkml.org 
[lkml]   [2022]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [RFC PATCH v7 00/16] Add support for qca8k mdio rw in Ethernet packet
From


On 1/30/2022 5:59 AM, Ansuel Smith wrote:
>>
>
> Hi,
> sorry for the delay in sending v8, it's ready but I'm far from home and
> I still need to check some mdio improvement with pointer handling.
>
> Anyway I have some concern aboutall the skb alloc.
> I wonder if that part can be improved at the cost of some additional
> space used.
>
> The idea Is to use the cache stuff also for the eth skb (or duplicate
> it?) And use something like build_skb and recycle the skb space
> everytime...
> This comes from the fact that packet size is ALWAYS the same and it
> seems stupid to allocate and free it everytime. Considering we also
> enforce a one way transaction (we send packet and we wait for response)
> this makes the allocation process even more stupid.
>
> So I wonder if we would have some perf improvement/less load by
> declaring the mgmt eth space and build an skb that always use that
> preallocate space and just modify data.
>
> I would really love some feedback considering qca8k is also used in very
> low spec ath79 device where we need to reduce the load in every way
> possible. Also if anyone have more ideas on how to improve this to make
> it less heavy cpu side, feel free to point it out even if it would
> mean that my implemenation is complete sh*t.
>
> (The use of caching the address would permit us to reduce the write to
> this preallocated space even more or ideally to send the same skb)

I would say first things first: get this patch series included since it
is very close from being suitable for inclusion in net-next. Then you
can profile the I/O accesses over the management Ethernet frames and
devise a strategy to optimize them to make as little CPU cycles
intensive as possible.

build_skb() is not exactly a magic bullet that will solve all
performance problems, you still need the non-data portion of the skb to
be allocated, and also keep in mind that you need tail room at the end
of the data buffer in order for struct skb_shared_info to be written.
This means that the hardware is not allowed to write at the end of the
data buffer, or you must reduce the maximum RX length accordingly to
prevent that. Your frames are small enough here this is unlikely to be
an issue.

Since the MDIO layer does not really allow more than one outstanding
transaction per MDIO device at a time, you might be just fine with just
have a front and back skb set of buffers and alternating between these two.
--
Florian

\
 
 \ /
  Last update: 2022-01-30 18:08    [W:0.270 / U:0.280 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site