Messages in this thread Patch in this message | | | From | Detlev Casanova <> | Subject | [PATCH v3 9/9] regulator/rpi-panel-attiny: Use two transactions for I2C read | Date | Mon, 24 Jan 2022 17:01:29 -0500 |
| |
From: Dave Stevenson <dave.stevenson@raspberrypi.com>
The I2C to the Atmel is very fussy, and locks up easily on Pi0-3 particularly on reads. If running at 100kHz on Pi3, reading the ID register generally locks up the Atmel, but splitting the register select write and read into two transactions is reliable.
Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.com> Signed-off-by: Detlev Casanova <detlev.casanova@collabora.com> --- .../regulator/rpi-panel-attiny-regulator.c | 35 ++++++++++++++++++- 1 file changed, 34 insertions(+), 1 deletion(-)
diff --git a/drivers/regulator/rpi-panel-attiny-regulator.c b/drivers/regulator/rpi-panel-attiny-regulator.c index 6e408a4b2c21..f7df0f4b2f87 100644 --- a/drivers/regulator/rpi-panel-attiny-regulator.c +++ b/drivers/regulator/rpi-panel-attiny-regulator.c @@ -250,6 +250,39 @@ static void attiny_gpio_set(struct gpio_chip *gc, unsigned int off, int val) mutex_unlock(&state->lock); } +static int attiny_i2c_read(struct i2c_client *client, u8 reg, unsigned int *buf) +{ + struct i2c_msg msgs[1]; + u8 addr_buf[1] = { reg }; + u8 data_buf[1] = { 0, }; + int ret; + + /* Write register address */ + msgs[0].addr = client->addr; + msgs[0].flags = 0; + msgs[0].len = ARRAY_SIZE(addr_buf); + msgs[0].buf = addr_buf; + + ret = i2c_transfer(client->adapter, msgs, ARRAY_SIZE(msgs)); + if (ret != ARRAY_SIZE(msgs)) + return -EIO; + + usleep_range(5000, 10000); + + /* Read data from register */ + msgs[0].addr = client->addr; + msgs[0].flags = I2C_M_RD; + msgs[0].len = 1; + msgs[0].buf = data_buf; + + ret = i2c_transfer(client->adapter, msgs, ARRAY_SIZE(msgs)); + if (ret != ARRAY_SIZE(msgs)) + return -EIO; + + *buf = data_buf[0]; + return 0; +} + /* * I2C driver interface functions */ @@ -280,7 +313,7 @@ static int attiny_i2c_probe(struct i2c_client *i2c, goto error; } - ret = regmap_read(regmap, REG_ID, &data); + ret = attiny_i2c_read(i2c, REG_ID, &data); if (ret < 0) { dev_err(&i2c->dev, "Failed to read REG_ID reg: %d\n", ret); goto error; -- 2.34.1
| |