lkml.org 
[lkml]   [2022]   [Jan]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2] hv: account for packet descriptor in maximum packet size
On Thu, Jan 20, 2022 at 2:12 AM Michael Kelley (LINUX)
<mikelley@microsoft.com> wrote:
>
> From: Wei Liu <wei.liu@kernel.org> Sent: Friday, January 14, 2022 11:13 AM
> >
> > On Mon, Jan 10, 2022 at 01:44:19AM +0100, Andrea Parri wrote:
> > > (Extending Cc: list,)
> > >
> > > On Sun, Jan 09, 2022 at 05:55:16PM +0800, Yanming Liu wrote:
> > > > Commit adae1e931acd ("Drivers: hv: vmbus: Copy packets sent by Hyper-V
> > > > out of the ring buffer") introduced a notion of maximum packet size in
> > > > vmbus channel and used that size to initialize a buffer holding all
> > > > incoming packet along with their vmbus packet header. Currently, some
> > > > vmbus drivers set max_pkt_size to the size of their receive buffer
> > > > passed to vmbus_recvpacket, however vmbus_open expects this size to also
> > > > include vmbus packet header. This leads to corruption of the ring buffer
> > > > state when receiving a maximum sized packet.
> > > >
> > > > Specifically, in hv_balloon I have observed of a dm_unballoon_request
> > > > message of 4096 bytes being truncated to 4080 bytes. When the driver
> > > > tries to read next packet it starts from a wrong read_index, receives
> > > > garbage and prints a lot of "Unhandled message: type: <garbage>" in
> > > > dmesg.
> > > >
> > > > The same mismatch also happens in hv_fcopy, hv_kvp, hv_snapshot,
> > > > hv_util, hyperv_drm and hyperv_fb, though bad cases are not observed
> > > > yet.
> > > >
> > > > Allocate the buffer with HV_HYP_PAGE_SIZE more bytes to make room for
> > > > the descriptor, assuming the vmbus packet header will never be larger
> > > > than HV_HYP_PAGE_SIZE. This is essentially free compared to just adding
> > > > 'sizeof(struct vmpacket_descriptor)' because these buffers are all more
> > > > than HV_HYP_PAGE_SIZE bytes so kmalloc rounds them up anyway.
> > > >
> > > > Fixes: adae1e931acd ("Drivers: hv: vmbus: Copy packets sent by Hyper-V out of the ring buffer")
> > > > Suggested-by: Andrea Parri (Microsoft) <parri.andrea@gmail.com>
> > > > Signed-off-by: Yanming Liu <yanminglr@gmail.com>
> > >
> > > Thanks for sorting this out; the patch looks good to me:
> > >
> > > Reviewed-by: Andrea Parri (Microsoft) <parri.andrea@gmail.com>
> > >
> >
> > Thanks. I will pick this up after 5.17-rc1 is out.
> >
> > Wei.
>
> I'm NACK'ing this set of changes. I've spent some further time investigating,
> so let me explain.
>
> I'm good with the overall approach of fixing individual drivers to set the
> max_pkt_size to account for the VMbus packet header, as this is an
> important aspect that was missed in the original coding. But interestingly,
> all but one of the miscellaneous VMbus drivers allocate significantly more
> receive buffer space than is actually needed, and the max_pkt_size matching
> that receive buffer size is already bigger than needed. In all these
> cases, there is already plenty of space for the VMbus packet header.
>

Appreciate for the additional insight on what Hyper-V would do!

> These hv-util.c drivers allocate a receive buffer 4 Kbytes in size, and all
> receive only small fixed-size packets: heartbeat, shutdown, timesync.
> I don't think any changes are needed for these drivers because the default
> max_pkt_size value of 4 Kbytes bytes is plenty of space even when
> accounting for the VMbus packet header.
>
> The VSS driver in hv_snapshot.c allocates a receive buffer of 8 Kbytes
> and sets max_pkt_size to 8 Kbytes. But the received messages are
> all fixed size and small. I don't know why the driver uses an 8 Kbyte
> receive buffer instead of 4 Kbytes, but the current settings are
> more than sufficient.
>

Well, I'm not sure, on August 2021 there was a patch changing
max_pkt_size to 8 KiB for VSS driver:
https://lore.kernel.org/linux-hyperv/20210825190217.qh2c6yq5qr3ntum5@liuwe-devbox-debian-v2/T/

The patch mentioned a 6304 bytes VSS message. Which is part of the
reason I tried to address the more "general" problem of potentially
mismatching buffer size.

> The FCOPY driver in hv_fcopy.c allocates a receive buffer of 8 Kbytes
> and sets max_pkt_size to 8 Kbytes. The received messages have
> some header overhead plus up to 6 Kbytes of data, so the 8 Kbyte
> receive buffer is definitely needed. And while this one is a little
> closer to filling up the available receive space than the previous
> ones, there's still plenty of room for the VMbus packet header. I
> don't think any changes are needed.
>
> The KVP driver in hv_kvp.c allocates a receive buffer of 16 Kbytes
> and sets max_pkt_size to 16 Kbytes. From what I can tell, the
> received messages max out at close to 4 Kbytes. Key exchange
> messages have 512 bytes of key name and 2048 bytes of key
> value, plus some header overhead. ipaddr_value messages
> are the largest, with 3 IP addresses @ 1024 bytes each, plus
> a gateway with 512 bytes, and an adapter ID with 128 bytes.
> But altogether, that is still less than 4096. I don't know why
> the receive buffer is 16 Kbytes, but it is plenty big and no
> changes are needed.
>
> The two frame buffer drivers also use 16 Kbyte receive buffers
> and set max_pkt_size to 16 Kbytes. Again, this looks to be overkill
> as the messages received are mostly fixed size. One message
> returns a variable size list of supported screen resolutions, but
> each entry in the list is only 4 bytes, and we're looking at a few
> tens of resolutions at the very most. Again, no changes are
> needed.
>
> After all this analysis, the balloon driver is the only one that
> needs changing. It uses a 4 Kbyte receive buffer, and indeed
> Hyper-V may fill that receive buffer in the case of unballoon
> messages. And that where the original problem was observed.
>
> Two other aspects for completeness. First, all these drivers
> do protocol version negotiation with the Hyper-V host. The
> negotiation includes a variable-size list of supported versions.
> Each version in the list takes 4 bytes, but there would never
> be enough different versions to come close to filling a 4 Kbyte
> buffer. So there's no problem here.
>
> The other lurking issue is the 'offset8' field in the VMbus
> packet header, which says where the payload starts relative
> to the VMbus packet header. In practice, this value is always
> small, so there's no significant additional space to account
> for. While it's theoretically possible that Hyper-V could use
> a much larger value, and cause max_pkt_size to be exceeded,
> there's no real way to fix this problem. Adding an extra page
> to max_pkt_size, as it done in this patch, certainly provides
> some extra room, but doesn't guarantee the problem can't
> happen. But since there's no indication Hyper-V would ever
> put a big value into offset8, I don't think we need to worry
> about the possibility.
>

Thanks for confirming this!

> My bottom-line: Let's fix the balloon driver. But now
> that we know the other drivers are safe "as is", let's leave
> them unchanged and not waste the additional memory.
>

Sure, after all I just want a working kernel :)

> Michael

\
 
 \ /
  Last update: 2022-01-19 21:15    [W:0.046 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site