lkml.org 
[lkml]   [2022]   [Jan]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] spi: stm32: remove inexistant variables in struct stm32_spi_cfg comment
Date
Variables 'can_dma' and 'has_startbit' are described within the
struct stm32_spi_cfg comment but have never existed in this structure
so remove them.

Signed-off-by: Alain Volmat <alain.volmat@foss.st.com>
---
drivers/spi/spi-stm32.c | 2 --
1 file changed, 2 deletions(-)

diff --git a/drivers/spi/spi-stm32.c b/drivers/spi/spi-stm32.c
index 9bd3fd1652f7..b5ef2470cefe 100644
--- a/drivers/spi/spi-stm32.c
+++ b/drivers/spi/spi-stm32.c
@@ -221,7 +221,6 @@ struct stm32_spi;
* time between frames (if driver has this functionality)
* @set_number_of_data: optional routine to configure registers to desired
* number of data (if driver has this functionality)
- * @can_dma: routine to determine if the transfer is eligible for DMA use
* @transfer_one_dma_start: routine to start transfer a single spi_transfer
* using DMA
* @dma_rx_cb: routine to call after DMA RX channel operation is complete
@@ -232,7 +231,6 @@ struct stm32_spi;
* @baud_rate_div_min: minimum baud rate divisor
* @baud_rate_div_max: maximum baud rate divisor
* @has_fifo: boolean to know if fifo is used for driver
- * @has_startbit: boolean to know if start bit is used to start transfer
*/
struct stm32_spi_cfg {
const struct stm32_spi_regspec *regs;
--
2.25.1
\
 
 \ /
  Last update: 2022-01-19 10:34    [W:0.105 / U:0.588 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site