lkml.org 
[lkml]   [2022]   [Jan]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v5] powerpc/pseries: read the lpar name from the firmware
From
On 11/01/2022, 23:40:27, Michael Ellerman wrote:
> Tyrel Datwyler <tyreld@linux.ibm.com> writes:
>> On 1/6/22 8:13 AM, Laurent Dufour wrote:
>>> The LPAR name may be changed after the LPAR has been started in the HMC.
>>> In that case lparstat command is not reporting the updated value because it
>>> reads it from the device tree which is read at boot time.
>>>
>>> However this value could be read from RTAS.
>>>
>>> Adding this value in the /proc/powerpc/lparcfg output allows to read the
>>> updated value.
>>>
>>> However the hypervisor, like Qemu/KVM, may not support this RTAS
>>> parameter. In that case the value reported in lparcfg is read from the
>>> device tree and so is not updated accordingly.
>>>
>>> Cc: Nathan Lynch <nathanl@linux.ibm.com>
>>> Signed-off-by: Laurent Dufour <ldufour@linux.ibm.com>
>>
>> My only nit would be that in general for consistency with other function names
>> _RTAS_ and _DT_ should be lowercase. Seeing as they are statically scoped within
>> lparcfg.c maybe its ok. Otherwise,
>
> Yeah I agree, I changed them to lower case when applying.

Thanks Michael and Tyrel.

\
 
 \ /
  Last update: 2022-01-12 14:10    [W:0.051 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site