lkml.org 
[lkml]   [2021]   [Sep]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 0/3] Apple Mailbox Controller support
On Tue, Sep 7, 2021 at 9:55 AM Sven Peter <sven@svenpeter.dev> wrote:
>
> Hi,
>
> This series adds support for the mailbox HW found in the Apple M1. These SoCs
> have various co-processors controlling different peripherals (NVMe, display
> controller, SMC (required for WiFi), Thunderbolt, and probably more
> we don't know about yet). All these co-processors communicate with the main CPU
> using these mailboxes. These mailboxes transmit 64+32 bit messages, are
> backed by a hardware FIFO and have four interrupts (FIFO empty and FIFO not
> empty for the transmit and receive FIFO each).
>
> The hardware itself allows to send 64+32 bit message using two hardware
> registers. A write to or read from the second register transmits or receives a
> message. Usually, the first 64 bit register is used for the message itself and
> 8 bits of the second register are used as an endpoint. I originally considered
> to have the endpoint exposed as a mailbox-channel, but finally decided against
> it: The hardware itself only provides a single channel to the co-processor and
> the endpoint bits are only an implementation detail of the firmware. There's
> even one co-processor (SEP) which uses 8 bits of the first register as its
> endpoint number instead.
> There was a similar discussion about the BCM2835 / Raspberry Pi mailboxes
> which came to the same conclusion [1].
>
> These mailboxes also have a hardware FIFO which make implementing them with the
> current mailbox a bit tricky: There is no "transmission done" interrupt because
> most transmissions are "done" immediately. There is only a "transmission fifo
> empty" level interrupt. I have instead implemented this by adding a fast-path to
> the core mailbox code as a new txready_fifo mode.
> The other possibilities (which would not require any changes to the core mailbox
> code) are to either use the polling mode or to enable the "tx fifo empty"
> interrupt in send_message and then call txready from the irq handler before
> disabling it again. I'd like to avoid those though since so far I've never seen
> the TX FIFO run full which allows to almost always avoid the context switch when
> sending a message. I can easily switch to one of these modes if you prefer to
> keep the core code untouched though.
>
Yes, please keep the api unchanged.
Let us please not dig our own tunnels when the existing ways serve the purpose.

Thanks.

\
 
 \ /
  Last update: 2021-09-08 22:49    [W:0.118 / U:0.748 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site