lkml.org 
[lkml]   [2021]   [Sep]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v1 2/2] mmc: sdhci: Use the SW timer when the HW timer cannot meet the timeout value required by the device
From
Date
On 24/09/21 4:08 pm, Bean Huo wrote:
> On Fri, 2021-09-24 at 15:17 +0300, Adrian Hunter wrote:
>>>>> sdhci_writeb(host, count, SDHCI_TIMEOUT_CONTROL);
>>>>> }
>>>>> The driver has detected that the hardware timer cannot meet the
>>>>> timeout
>>>>> requirements of the device, but we still use the hardware
>>>>> timer,
>>>>> which will
>>>>> allow potential timeout issuea . Rather than allowing a
>>>>> potential
>>>>> problem to exist, why can’t software timing be used to avoid
>>>>> this
>>>>> problem?
>>>> Timeouts aren't that accurate. The maximum is assumed still to
>>>> work.
>>>> mmc->max_busy_timeout is used to tell the core what the maximum
>>>> is.
>>> mmc->max_busy_timeout is still a representation of Host HW timer
>>> maximum timeout count, isn't it?
>>
>>
>> Not necessarily. For SDHCI_QUIRK2_DISABLE_HW_TIMEOUT it would be
>>
>> set to zero to indicate no maximum.
>
> yes, this is the purpose of the patch, for the host controller without
> quirk SDHCI_QUIRK2_DISABLE_HW_TIMEOUT, if the timeout count required by
> device is beyond the HW timer max count, we choose SW timer to avoid the HW timer timeout IRQ.
>
> I don't know if I get it correctly.

Why can't drivers that want the behaviour just set the quirk?

Drivers that do not work with the quirk, do not have to set it.

\
 
 \ /
  Last update: 2021-09-24 15:27    [W:0.086 / U:2.368 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site