lkml.org 
[lkml]   [2021]   [Aug]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V2 2/3] KVM: X86: Set the hardware DR6 only when KVM_DEBUGREG_WONT_EXIT
Date
From: Lai Jiangshan <laijs@linux.alibaba.com>

Commit c77fb5fe6f03 ("KVM: x86: Allow the guest to run with dirty debug
registers") allows the guest accessing to DRs without exiting when
KVM_DEBUGREG_WONT_EXIT and we need to ensure that they are synchronized
on entry to the guest---including DR6 that was not synced before the commit.

But the commit sets the hardware DR6 not only when KVM_DEBUGREG_WONT_EXIT,
but also when KVM_DEBUGREG_BP_ENABLED. The second case is unnecessary
and just leads to a more case which leaks stale DR6 to the host which has
to be resolved by unconditionally reseting DR6 in kvm_arch_vcpu_put().

We'd better to set the hardware DR6 only when KVM_DEBUGREG_WONT_EXIT,
so that we can fine-grain control the cases when we need to reset it
which is done in later patch.

Signed-off-by: Lai Jiangshan <laijs@linux.alibaba.com>
---
arch/x86/kvm/x86.c | 4 +++-
1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/arch/x86/kvm/x86.c b/arch/x86/kvm/x86.c
index ad47a09ce307..d2aa49722064 100644
--- a/arch/x86/kvm/x86.c
+++ b/arch/x86/kvm/x86.c
@@ -9598,7 +9598,9 @@ static int vcpu_enter_guest(struct kvm_vcpu *vcpu)
set_debugreg(vcpu->arch.eff_db[1], 1);
set_debugreg(vcpu->arch.eff_db[2], 2);
set_debugreg(vcpu->arch.eff_db[3], 3);
- set_debugreg(vcpu->arch.dr6, 6);
+ /* When KVM_DEBUGREG_WONT_EXIT, dr6 is accessible in guest. */
+ if (vcpu->arch.switch_db_regs & KVM_DEBUGREG_WONT_EXIT)
+ set_debugreg(vcpu->arch.dr6, 6);
} else if (unlikely(hw_breakpoint_active())) {
set_debugreg(0, 7);
}
--
2.19.1.6.gb485710b
\
 
 \ /
  Last update: 2021-08-10 05:29    [W:0.113 / U:0.396 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site