lkml.org 
[lkml]   [2021]   [Aug]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [RFC] mm: optimise generic_file_read_iter
Date
On 8/6/21 2:48 PM, Al Viro wrote:
> On Fri, Aug 06, 2021 at 12:42:43PM +0100, Pavel Begunkov wrote:
>> Unless direct I/O path of generic_file_read_iter() ended up with an
>> error or a short read, it doesn't use inode. So, load inode and size
>> later, only when they're needed. This cuts two memory reads and also
>> imrpoves code generation, e.g. loads from stack.
>
> ... and the same question here.
>
>> NOTE: as a side effect, it reads inode->i_size after ->direct_IO(), and
>> I'm not sure whether that's valid, so would be great to get feedback
>> from someone who knows better.
>
> Ought to be safe, I think, but again, how much effect have you observed
> from the patch?

Answering for both patches -- I haven't benchmarked it and don't expect
to find anything just from this one, considering variance between runs.
I took a loot at the assembly (gcc 11.1), it removes 2 reads to get
i_size, write+read that i_size from stack, because it stashed it on
the stack.

For example, we've squeezed several percents of throughput before on
the io_uring side just by cutting sheer number of not too expensive
individually instructions. IMHO, it's easier to do when you spotted
something by the way, than rediscovering the same during a performance
safari.

--
Pavel Begunkov

\
 
 \ /
  Last update: 2021-08-07 12:33    [W:0.056 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site