lkml.org 
[lkml]   [2021]   [Aug]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] xhci: Set HCD flag to defer primary roothub registration
Date
Set "HCD_FLAG_DEFER_PRI_RH_REGISTER" to hcd->flags in xhci_run() to defer
registering primary roothub in usb_add_hcd(). This will make sure both
primary roothub and secondary roothub will be registered along with the
second HCD. This is required for cold plugged USB devices to be detected
in certain PCIe USB cards (like Inateck USB card connected to AM64 EVM
or J7200 EVM).

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
Suggested-by: Mathias Nyman <mathias.nyman@linux.intel.com>
---
drivers/usb/host/xhci.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 3618070eba78..9b7d968022c8 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -644,7 +644,6 @@ int xhci_run(struct usb_hcd *hcd)
/* Start the xHCI host controller running only after the USB 2.0 roothub
* is setup.
*/
-
hcd->uses_new_polling = 1;
if (!usb_hcd_is_primary_hcd(hcd))
return xhci_run_finished(xhci);
@@ -692,6 +691,7 @@ int xhci_run(struct usb_hcd *hcd)
if (ret)
xhci_free_command(xhci, command);
}
+ set_bit(HCD_FLAG_DEFER_PRI_RH_REGISTER, &hcd->flags);
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"Finished xhci_run for USB2 roothub");

--
2.17.1
\
 
 \ /
  Last update: 2021-08-25 12:52    [W:0.278 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site