Messages in this thread | | | Subject | Re: [PATCH V3 3/3] gpio: modepin: Add driver support for modepin GPIO controller | From | Michal Simek <> | Date | Mon, 23 Aug 2021 10:14:11 +0200 |
| |
Hi Bart,
On 8/23/21 10:02 AM, Bartosz Golaszewski wrote: > On Wed, Aug 18, 2021 at 10:11 AM Piyush Mehta <piyush.mehta@xilinx.com> wrote: >> >> This patch adds driver support for the zynqmp modepin GPIO controller. >> GPIO modepin driver set and get the value and status of the PS_MODE pin, >> based on device-tree pin configuration. These four mode pins are >> configurable as input/output. The mode pin has a control register, which >> have lower four-bits [0:3] are configurable as input/output, next four-bits >> can be used for reading the data as input[4:7], and next setting the >> output pin state output[8:11]. >> >> Signed-off-by: Piyush Mehta <piyush.mehta@xilinx.com> >> Acked-by: Michal Simek <michal.simek@xilinx.com> >> Reviewed-by: Linus Walleij <linus.walleij@linaro.org> >> --- > > Which tree should this go through?
I would prefer to go this via gpio tree.
Thanks, Michal
| |