lkml.org 
[lkml]   [2021]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH devicetree 1/2] MIPS: mscc: ocelot: disable all switch ports by default
On Thu, Aug 19, 2021 at 08:04:15PM +0300, Vladimir Oltean wrote:
> The ocelot switch driver used to ignore ports which do not have a
> phy-handle property and not probe those, but this is not quite ok since
> it is valid to not have a phy-handle property if there is a fixed-link.
>
> It seems that checking for a phy-handle was a proxy for the proper check
> which is for the status, but that doesn't make a lot of sense, since the
> ocelot driver already iterates using for_each_available_child_of_node
> which skips the disabled ports, so I have no idea.
>
> Anyway, a widespread pattern in device trees is for a SoC dtsi to
> disable by default all hardware, and let board dts files enable what is
> used. So let's do that and enable only the ports with a phy-handle in
> the pcb120 and pcb123 device tree files.
>
> Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
> ---
> arch/mips/boot/dts/mscc/ocelot.dtsi | 11 +++++++++++
> arch/mips/boot/dts/mscc/ocelot_pcb120.dts | 8 ++++++++
> arch/mips/boot/dts/mscc/ocelot_pcb123.dts | 4 ++++
> 3 files changed, 23 insertions(+)

applied to mips-next.

Thomas.

--
Crap can work. Given enough thrust pigs will fly, but it's not necessarily a
good idea. [ RFC1925, 2.3 ]

\
 
 \ /
  Last update: 2021-08-21 11:26    [W:0.048 / U:1.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site