lkml.org 
[lkml]   [2021]   [Aug]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH net-next 1/1] net: phy: marvell10g: Add WAKE_PHY support to WOL event
> How does this work if the driver has no interrupt support? What is
> the hardware setup this has been tested with?

Hi Russell

We already know from previous patches that the Intel hardware is
broken, and does not actually deliver the interrupt which caused the
wake up. So i assume this just continues on with the same broken
hardware, but they have a different PHY connected.

> What if we later want to add interrupt support to this driver to
> support detecting changes in link state - isn't using this bit
> in the interrupt enable register going to confict with that?

Agreed. If the interrupt register is being used, i think we need this
patchset to add proper interrupt support. Can you recommend a board
they can buy off the shelf with the interrupt wired up? Or maybe Intel
can find a hardware engineer to add a patch wire to link the interrupt
output to a SoC pin that can do interrupts.

Andrew

\
 
 \ /
  Last update: 2021-08-14 20:05    [W:0.387 / U:0.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site