Messages in this thread | | | From | 赵振国 <> | Date | Wed, 7 Jul 2021 14:08:40 +0800 | Subject | Re: [PATCH v2] tty: n_gsm: CR bit value should be 0 when config "initiator=0" |
| |
Dear Jiri,Greg
1: our development board uses linux kernel , uart dev node is "/dev/ttyGS2" 2: config uart "/dev/ttyGS2" ,we use ngsm ldisc,and config "c.initiator = 0;" code is as follows
#include <stdio.h> #include <stdint.h> #include <linux/gsmmux.h> #include <linux/tty.h> #define DEFAULT_SPEED B115200 #define SERIAL_PORT /dev/ttyGS2
int ldisc = N_GSM0710; struct gsm_config c; struct termios configuration; uint32_t first;
/* open the serial port */ fd = open(SERIAL_PORT, O_RDWR | O_NOCTTY | O_NDELAY);
/* configure the serial port : speed, flow control ... */
/* use n_gsm line discipline */ ioctl(fd, TIOCSETD, &ldisc);
/* get n_gsm configuration */ ioctl(fd, GSMIOC_GETCONF, &c); /* we are responter and need encoding 0 (basic) */ c.initiator = 0; c.encapsulation = 0; /* our modem defaults to a maximum size of 127 bytes */ c.mru = 127; c.mtu = 127; /* set the new configuration */ ioctl(fd, GSMIOC_SETCONF, &c); /* get first gsmtty device node */ ioctl(fd, GSMIOC_GETFIRST, &first); printf("first muxed line: /dev/gsmtty%i\n", first);
/* and wait for ever to keep the line discipline enabled */ daemon(0,0); pause();
3: connect to ubuntu by uart serial port cable,ubuntu uart dev node is /"dev/ttyUSB0" send DLC0 SABM command by "/dev/ttyUSB0",but linux development board can't response,code is as follows
int main(int argc, char **argv) { int fd; fd = open("/dev/ttyUSB0,O_RDWR | O_NOCTTY | O_NDELAY); char buf[256]={0xf9,0x03,0x3f,0x01,0x1c,0xf9}; write(fd,buf,6); close(fd); }
4: linux development board receive data,by uart,gsm_queue will check CR,find CR=1.so go to invalid,pls check again. static void gsm_queue(struct gsm_mux *gsm) { cr ^= 1 - gsm->initiator; /* Flip so 1 always means command */ dlci = gsm->dlci[address];
switch (gsm->control) { case SABM|PF: if (cr == 0) goto invalid; if (dlci == NULL) dlci = gsm_dlci_alloc(gsm, address); if (dlci == NULL) return; if (dlci->dead) gsm_response(gsm, address, DM); else { gsm_response(gsm, address, UA); gsm_dlci_open(dlci); } break;
| |