lkml.org 
[lkml]   [2021]   [Jul]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH AUTOSEL 5.12 046/160] net: stmmac: the XPCS obscures a potential "PHY not found" error
Date
From: Vladimir Oltean <vladimir.oltean@nxp.com>

[ Upstream commit 4751d2aa321f2828d8c5d2f7ce4ed18a01e47f46 ]

stmmac_mdio_register() has logic to search for PHYs on the MDIO bus and
assign them IRQ lines, as well as to set priv->plat->phy_addr.

If no PHY is found, the "found" variable remains set to 0 and the
function errors out.

After the introduction of commit f213bbe8a9d6 ("net: stmmac: Integrate
it with DesignWare XPCS"), the "found" variable was immediately reused
for searching for a PCS on the same MDIO bus.

This can result in 2 types of potential problems (none of them seems to
be seen on the only Intel system that sets has_xpcs = true, otherwise it
would have been reported):

1. If a PCS is found but a PHY is not, then the code happily exits with
no error. One might say "yes, but this is not possible, because
of_mdiobus_register will probe a PHY for all MDIO addresses,
including for the XPCS, so if an XPCS exists, then a PHY certainly
exists too". Well, that is not true, see intel_mgbe_common_data():

/* Ensure mdio bus scan skips intel serdes and pcs-xpcs */
plat->mdio_bus_data->phy_mask = 1 << INTEL_MGBE_ADHOC_ADDR;
plat->mdio_bus_data->phy_mask |= 1 << INTEL_MGBE_XPCS_ADDR;

2. A PHY is found but an MDIO device with the XPCS PHY ID isn't, and in
that case, the error message will be "No PHY found". Confusing.

Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
Link: https://lore.kernel.org/r/20210527155959.3270478-1-olteanv@gmail.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
.../net/ethernet/stmicro/stmmac/stmmac_mdio.c | 21 +++++++++++++------
1 file changed, 15 insertions(+), 6 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index d64116e0543e..a4ba27bf3131 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
@@ -444,6 +444,12 @@ int stmmac_mdio_register(struct net_device *ndev)
found = 1;
}

+ if (!found && !mdio_node) {
+ dev_warn(dev, "No PHY found\n");
+ err = -ENODEV;
+ goto no_phy_found;
+ }
+
/* Try to probe the XPCS by scanning all addresses. */
if (priv->hw->xpcs) {
struct mdio_xpcs_args *xpcs = &priv->hw->xpcs_args;
@@ -452,6 +458,7 @@ int stmmac_mdio_register(struct net_device *ndev)

xpcs->bus = new_bus;

+ found = 0;
for (addr = 0; addr < max_addr; addr++) {
xpcs->addr = addr;

@@ -461,13 +468,12 @@ int stmmac_mdio_register(struct net_device *ndev)
break;
}
}
- }

- if (!found && !mdio_node) {
- dev_warn(dev, "No PHY found\n");
- mdiobus_unregister(new_bus);
- mdiobus_free(new_bus);
- return -ENODEV;
+ if (!found && !mdio_node) {
+ dev_warn(dev, "No XPCS found\n");
+ err = -ENODEV;
+ goto no_xpcs_found;
+ }
}

bus_register_done:
@@ -475,6 +481,9 @@ int stmmac_mdio_register(struct net_device *ndev)

return 0;

+no_xpcs_found:
+no_phy_found:
+ mdiobus_unregister(new_bus);
bus_register_fail:
mdiobus_free(new_bus);
return err;
--
2.30.2
\
 
 \ /
  Last update: 2021-07-06 13:40    [W:0.628 / U:0.352 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site