lkml.org 
[lkml]   [2021]   [Jul]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v1 2/2] PCI: PM: Enable PME if it can be signaled from D3cold
On Fri, Jul 30, 2021 at 12:28 PM Mika Westerberg
<mika.westerberg@linux.intel.com> wrote:
>
> On Thu, Jul 29, 2021 at 04:49:10PM +0200, Rafael J. Wysocki wrote:
> > From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
> >
> > PME signaling is only enabled by __pci_enable_wake() if the target
> > device can signal PME from the given target power state (to avoid
> > pointless reconfiguration of the device), but if the hierarchy above
> > the device goes into D3cold, the device itself will end up in D3cold
> > too, so if it can signal PME from D3cold, it should be enabled to
> > do so in __pci_enable_wake().
> >
> > [Note that if the device does not end up in D3cold and it cannot
> > signal PME from the original target power state, it will not signal
> > PME, so in that case the behavior does not change.]
> >
> > Link: https://lore.kernel.org/linux-pm/3149540.aeNJFYEL58@kreacher/
> > Fixes: 5bcc2fb4e815 ("PCI PM: Simplify PCI wake-up code")
> > Reported-by: Mika Westerberg <mika.westerberg@linux.intel.com>
>
> Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>
>
> Also this solves the reported issue so,
>
> Tested-by: Mika Westerberg <mika.westerberg@linux.intel.com>

Thank you!

I'll queue up these two patches for 5.15 barring any objections from Bjorn.

\
 
 \ /
  Last update: 2021-07-30 14:14    [W:0.044 / U:0.344 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site