lkml.org 
[lkml]   [2021]   [Jul]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v1 2/2] PCI: PM: Enable PME if it can be signaled from D3cold
On Thu, Jul 29, 2021 at 04:49:10PM +0200, Rafael J. Wysocki wrote:
> From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
>
> PME signaling is only enabled by __pci_enable_wake() if the target
> device can signal PME from the given target power state (to avoid
> pointless reconfiguration of the device), but if the hierarchy above
> the device goes into D3cold, the device itself will end up in D3cold
> too, so if it can signal PME from D3cold, it should be enabled to
> do so in __pci_enable_wake().
>
> [Note that if the device does not end up in D3cold and it cannot
> signal PME from the original target power state, it will not signal
> PME, so in that case the behavior does not change.]
>
> Link: https://lore.kernel.org/linux-pm/3149540.aeNJFYEL58@kreacher/
> Fixes: 5bcc2fb4e815 ("PCI PM: Simplify PCI wake-up code")
> Reported-by: Mika Westerberg <mika.westerberg@linux.intel.com>

Reviewed-by: Mika Westerberg <mika.westerberg@linux.intel.com>

Also this solves the reported issue so,

Tested-by: Mika Westerberg <mika.westerberg@linux.intel.com>

Thanks!

\
 
 \ /
  Last update: 2021-07-30 12:29    [W:0.067 / U:0.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site