lkml.org 
[lkml]   [2021]   [Jul]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/7] mfd: tqmx86: clear GPIO IRQ resource when no IRQ is set
Date
The driver was registering IRQ 0 when no IRQ was set. This leads to
warnings with newer kernels.

Clear the resource flags, so no resource is registered at all in this
case.

Fixes: 2f17dd34ffed ("mfd: tqmx86: IO controller with I2C, Wachdog and GPIO")
Signed-off-by: Matthias Schiffer <matthias.schiffer@ew.tq-group.com>
---

v2: add Fixes line

Andy recommended to use IORESOURCE_DISABLED instead, but this doesn't
have any effect for platform_get_irq(), so I'm resubmitting this patch
without functional changes. Grepping for '\.flags = 0;' shows other
drivers doing the same.


drivers/mfd/tqmx86.c | 2 ++
1 file changed, 2 insertions(+)

diff --git a/drivers/mfd/tqmx86.c b/drivers/mfd/tqmx86.c
index ddddf08b6a4c..732013f40e4e 100644
--- a/drivers/mfd/tqmx86.c
+++ b/drivers/mfd/tqmx86.c
@@ -209,6 +209,8 @@ static int tqmx86_probe(struct platform_device *pdev)

/* Assumes the IRQ resource is first. */
tqmx_gpio_resources[0].start = gpio_irq;
+ } else {
+ tqmx_gpio_resources[0].flags = 0;
}

ocores_platfom_data.clock_khz = tqmx86_board_id_to_clk_rate(board_id);
--
2.17.1
\
 
 \ /
  Last update: 2021-07-02 14:24    [W:0.118 / U:1.588 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site