lkml.org 
[lkml]   [2021]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH V1 2/2] mmc: sdhci-msm: Use maximum possible data timeout value
On Fri 16 Jul 09:03 CDT 2021, Sarthak Garg wrote:

> The Qcom SD controller defines the usage of 0xF in data
> timeout counter register (0x2E) which is actually a reserved
> bit as per specification. This would result in maximum of 21.26 secs
> timeout value.
>
> Some SDcard taking more time than 2.67secs (timeout value corresponding
> to 0xE) and with that observed data timeout errors.
> So increasing the timeout value to max possible timeout.
>
> Signed-off-by: Sahitya Tummala <stummala@codeaurora.org>

The From: of the email says you wrote the patch, but the first person to
certify its origin is Sahitya. Did you perhaps write this together? If
so you should have a:

Co-developed-by: Sahitya

If Sahitya wrote the patch, certifies its origin and then you picks it
up and certify that you got it from Sahitya, then you should write it as
you did - but you should have retained Sahitya as author...

Regards,
Bjorn

> Signed-off-by: Sarthak Garg <sartgarg@codeaurora.org>
> ---
> drivers/mmc/host/sdhci-msm.c | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index e44b7a6..19e4673 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -2696,6 +2696,9 @@ static int sdhci_msm_probe(struct platform_device *pdev)
>
> msm_host->mmc->caps |= MMC_CAP_WAIT_WHILE_BUSY | MMC_CAP_NEED_RSP_BUSY;
>
> + /* Set the timeout value to max possible */
> + host->max_timeout_count = 0xF;
> +
> pm_runtime_get_noresume(&pdev->dev);
> pm_runtime_set_active(&pdev->dev);
> pm_runtime_enable(&pdev->dev);
> --
> 2.7.4
>

\
 
 \ /
  Last update: 2021-07-17 01:56    [W:0.101 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site