lkml.org 
[lkml]   [2021]   [May]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 1/2] ARM: dts: da850-lego-ev3: align GPIO hog names with dt-schema
Date
The GPIO hog dt-schema node naming convention expect GPIO hogs node names
to end with a 'hog' suffix.

Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
---
arch/arm/boot/dts/da850-lego-ev3.dts | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/arch/arm/boot/dts/da850-lego-ev3.dts b/arch/arm/boot/dts/da850-lego-ev3.dts
index afd04a423856..1e86cde86406 100644
--- a/arch/arm/boot/dts/da850-lego-ev3.dts
+++ b/arch/arm/boot/dts/da850-lego-ev3.dts
@@ -412,14 +412,14 @@
status = "okay";

/* Don't pull down battery voltage adc io channel */
- batt_volt_en {
+ batt-volt-en-hog {
gpio-hog;
gpios = <6 GPIO_ACTIVE_HIGH>;
output-high;
};

/* Don't impede Bluetooth clock signal */
- bt_clock_en {
+ bt-clock-en-hog {
gpio-hog;
gpios = <5 GPIO_ACTIVE_HIGH>;
input;
@@ -433,19 +433,19 @@
* anything, but they are present in the source code from LEGO.
*/

- bt_pic_en {
+ bt-pic-en-hog {
gpio-hog;
gpios = <51 GPIO_ACTIVE_HIGH>;
output-low;
};

- bt_pic_rst {
+ bt-pic-rst-hog {
gpio-hog;
gpios = <78 GPIO_ACTIVE_HIGH>;
output-high;
};

- bt_pic_cts {
+ bt-pic-cts-hog {
gpio-hog;
gpios = <87 GPIO_ACTIVE_HIGH>;
input;
--
2.17.1
\
 
 \ /
  Last update: 2021-05-24 17:25    [W:0.722 / U:0.016 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site