lkml.org 
[lkml]   [2021]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH RESEND] ARM: dts: imx6dl-yapp4: Configure the OLED display segment offset
On Wed, May 12, 2021 at 11:55:14AM +0200, Michal Vokáč wrote:
> The imx6dl-yapp4 platform uses a GE-LX012864FWPP3N0000 OLED display.
> The display consist of a 128x64 OLED panel and a SSD1305 controller.
>
> The OLED panel resolution is 128x64 but the built-in controller default
> resolution is 132x64. To display properly a segment offset needs to be
> configured.
>
> Signed-off-by: Michal Vokáč <michal.vokac@ysoft.com>

Why are you resending? Please state reason when you resend.


Shawn

> ---
> arch/arm/boot/dts/imx6dl-yapp4-common.dtsi | 1 +
> 1 file changed, 1 insertion(+)
>
> diff --git a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
> index 51972c85e207..111d4d331f98 100644
> --- a/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
> +++ b/arch/arm/boot/dts/imx6dl-yapp4-common.dtsi
> @@ -373,6 +373,7 @@
> solomon,height = <64>;
> solomon,width = <128>;
> solomon,page-offset = <0>;
> + solomon,col-offset = <4>;
> solomon,prechargep2 = <15>;
> reset-gpios = <&gpio_oled 1 GPIO_ACTIVE_LOW>;
> vbat-supply = <&sw2_reg>;
> --
> 2.1.4
>

\
 
 \ /
  Last update: 2021-05-23 05:51    [W:0.170 / U:0.232 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site