lkml.org 
[lkml]   [2021]   [Apr]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC] mm/vmscan.c: avoid possible long latency caused by too_many_isolated()
On Thu, Apr 22, 2021 at 2:17 PM Tim Chen <tim.c.chen@linux.intel.com> wrote:
>
>
>
> On 4/22/21 10:13 AM, Yu Zhao wrote:
>
> > @@ -3302,6 +3252,7 @@ static bool throttle_direct_reclaim(gfp_t gfp_mask, struct zonelist *zonelist,
> > unsigned long try_to_free_pages(struct zonelist *zonelist, int order,
> > gfp_t gfp_mask, nodemask_t *nodemask)
> > {
> > + int nr_cpus;
> > unsigned long nr_reclaimed;
> > struct scan_control sc = {
> > .nr_to_reclaim = SWAP_CLUSTER_MAX,
> > @@ -3334,8 +3285,17 @@ unsigned long try_to_free_pages(struct zonelist *zonelist, int order,
> > set_task_reclaim_state(current, &sc.reclaim_state);
> > trace_mm_vmscan_direct_reclaim_begin(order, sc.gfp_mask);
> >
> > + nr_cpus = current_is_kswapd() ? 0 : num_online_cpus();
> > + while (nr_cpus && !atomic_add_unless(&pgdat->nr_reclaimers, 1, nr_cpus)) {
> > + if (schedule_timeout_killable(HZ / 10))
>
> 100 msec seems like a long time to wait. The original code in shrink_inactive_list
> choose 100 msec sleep because the sleep happens only once in the while loop and 100 msec was
> used to check for stalling. In this case the loop can go on for a while and the
> #reclaimers can go down below the sooner than 100 msec. Seems like it should be checked
> more often.

You are not looking at the original code -- the original code sleeps
indefinitely. It was changed by commit db73ee0d46 to fix a problem
that doesn't apply to the code above.

HZ/10 is purely arbitrary but that's ok because we assume normally
nobody hits it. If you do often, we need to figure out why and how not
to hit it so often.

\
 
 \ /
  Last update: 2021-04-22 22:30    [W:0.206 / U:0.792 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site