lkml.org 
[lkml]   [2021]   [Apr]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/2] phy: nxp-c45: add driver for tja1103
> +config NXP_C45_TJA11XX_PHY
> + tristate "NXP C45 TJA11XX PHYs"
> + help
> + Enable support for NXP C45 TJA11XX PHYs.
> + Currently supports only the TJA1103 PHY.

> +#define PHY_ID_BASE_T1 0x001BB010

It would be better to use PHY_ID_TJA_1103 here.

> +
> +#define PMAPMD_B100T1_PMAPMD_CTL 0x0834
> +#define B100T1_PMAPMD_CONFIG_EN BIT(15)
> +#define B100T1_PMAPMD_MASTER BIT(14)
> +#define MASTER_MODE (B100T1_PMAPMD_CONFIG_EN | \
> + B100T1_PMAPMD_MASTER)

You would normally align this with the B100T1_PMAPMD_CONFIG_EN

> +static int nxp_c45_reset_done(struct phy_device *phydev)
> +{
> + return !(phy_read_mmd(phydev, MDIO_MMD_VEND1, VEND1_DEVICE_CONTROL) &
> + DEVICE_CONTROL_RESET);
> +}
> +
> +static int nxp_c45_reset_done_or_timeout(struct phy_device *phydev,
> + ktime_t timeout)
> +{
> + ktime_t cur = ktime_get();
> +
> + return nxp_c45_reset_done(phydev) || ktime_after(cur, timeout);
> +}
> +
> +static int nxp_c45_soft_reset(struct phy_device *phydev)
> +{
> + ktime_t timeout;
> + int ret;
> +
> + ret = phy_write_mmd(phydev, MDIO_MMD_VEND1, VEND1_DEVICE_CONTROL,
> + DEVICE_CONTROL_RESET);
> + if (ret)
> + return ret;
> +
> + timeout = ktime_add_ns(ktime_get(), RESET_POLL_NS);
> + spin_until_cond(nxp_c45_reset_done_or_timeout(phydev, timeout));

phy_read_mmd_poll_timeout() i think does what you need.

> + if (!nxp_c45_reset_done(phydev)) {
> + phydev_err(phydev, "reset fail\n");
> + return -EIO;
> + }
> + return 0;
> +}

> +static struct phy_driver nxp_c45_driver[] = {
> + {
> + PHY_ID_MATCH_MODEL(PHY_ID_BASE_T1),
> + .name = "NXP C45 BASE-T1",

"NXP C45 TJA1103"

Andrew

\
 
 \ /
  Last update: 2021-04-16 00:57    [W:0.079 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site