lkml.org 
[lkml]   [2021]   [Apr]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V3 3/5] arm64: dts: qcom: pmr735a: Add temp-alarm support
Date
Add temp-alarm node for PMR735A pmic and also modify gpio
node to add gpio ranges and "qcom,spmi-gpio" compatible.

Signed-off-by: satya priya <skakit@codeaurora.org>
---
arch/arm64/boot/dts/qcom/pmr735a.dtsi | 32 +++++++++++++++++++++++++++++++-
1 file changed, 31 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/pmr735a.dtsi b/arch/arm64/boot/dts/qcom/pmr735a.dtsi
index 1c675af1..b4b6ba24 100644
--- a/arch/arm64/boot/dts/qcom/pmr735a.dtsi
+++ b/arch/arm64/boot/dts/qcom/pmr735a.dtsi
@@ -13,13 +13,43 @@
#address-cells = <1>;
#size-cells = <0>;

+ pmr735a_temp_alarm: temp-alarm@a00 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0xa00>;
+ interrupts = <0x4 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+ #thermal-sensor-cells = <0>;
+ };
+
pmr735a_gpios: gpio@8800 {
- compatible = "qcom,pmr735a-gpio";
+ compatible = "qcom,pmr735a-gpio", "qcom,spmi-gpio";
reg = <0x8800>;
gpio-controller;
+ gpio-ranges = <&pmr735a_gpios 0 0 4>;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
};
};
+
+&thermal_zones {
+ pmr735a_thermal: pmr735a-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <0>;
+ thermal-sensors = <&pmr735a_temp_alarm>;
+
+ trips {
+ pmr735a_trip0: trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
+
+ pmr735a_crit: pmr735a-crit {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "critical";
+ };
+ };
+ };
+};
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
\
 
 \ /
  Last update: 2021-04-14 10:35    [W:0.072 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site