lkml.org 
[lkml]   [2021]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 10/18] KVM: Move x86's MMU notifier memslot walkers to generic code
On Wed, Mar 31, 2021, Paolo Bonzini wrote:
> On 26/03/21 03:19, Sean Christopherson wrote:
> > +#ifdef KVM_ARCH_WANT_NEW_MMU_NOTIFIER_APIS
> > + kvm_handle_hva_range(mn, address, address + 1, pte, kvm_set_spte_gfn);
> > +#else
> > struct kvm *kvm = mmu_notifier_to_kvm(mn);
> > int idx;
> > trace_kvm_set_spte_hva(address);
> > idx = srcu_read_lock(&kvm->srcu);
> >
> > KVM_MMU_LOCK(kvm);
> >
> > kvm->mmu_notifier_seq++;
> >
> > if (kvm_set_spte_hva(kvm, address, pte))
> > kvm_flush_remote_tlbs(kvm);
> >
> > KVM_MMU_UNLOCK(kvm);
> > srcu_read_unlock(&kvm->srcu, idx);
> > +#endif
>
> The kvm->mmu_notifier_seq is missing in the new API side. I guess you can
> add an argument to __kvm_handle_hva_range and handle it also in patch 15
> ("KVM: Take mmu_lock when handling MMU notifier iff the hva hits a
> memslot").

Yikes. Superb eyes!

That does bring up an oddity I discovered when digging into this. Every call
to .change_pte() is bookended by .invalidate_range_{start,end}(), i.e. the above
missing kvm->mmu_notifier_seq++ is benign because kvm->mmu_notifier_count is
guaranteed to be non-zero.

I'm also fairly certain it means kvm_set_spte_gfn() is effectively dead code on
_all_ architectures. x86 and MIPS are clearcut nops if the old SPTE is
not-present, and that's guaranteed due to the prior invalidation. PPC simply
unmaps the SPTE, which again should be a nop due to the invalidation. arm64 is
a bit murky, but if I'm reading the code correctly, it's also a nop because
kvm_pgtable_stage2_map() is called without a cache pointer, which I think means
it will map an entry if and only if an existing PTE was found.

I haven't actually tested the above analysis, e.g. by asserting that
kvm->mmu_notifier_count is indeed non-zero. I'll do that sooner than later.
But, given the shortlog of commit:

6bdb913f0a70 ("mm: wrap calls to set_pte_at_notify with invalidate_range_start
and invalidate_range_end")

I'm fairly confident my analysis is correct. And if so, it also means that the
whole point of adding .change_pte() in the first place (for KSM, commit
828502d30073, "ksm: add mmu_notifier set_pte_at_notify()"), has since been lost.

When it was originally added, .change_pte() was a pure alternative to
invalidating the entry.

void __mmu_notifier_change_pte(struct mm_struct *mm, unsigned long address,
pte_t pte)
{
struct mmu_notifier *mn;
struct hlist_node *n;

rcu_read_lock();
hlist_for_each_entry_rcu(mn, n, &mm->mmu_notifier_mm->list, hlist) {
if (mn->ops->change_pte)
mn->ops->change_pte(mn, mm, address, pte);
/*
* Some drivers don't have change_pte,
* so we must call invalidate_page in that case.
*/
else if (mn->ops->invalidate_page)
mn->ops->invalidate_page(mn, mm, address);
}
rcu_read_unlock();
}

The aforementioned commit 6bdb913f0a70 wrapped set_pte_at_notify() with
invalidate_range_{start,end}() so that .invalidate_page() implementations could
sleep. But, no one noticed that in doing so, .change_pte() was completely
neutered.

Assuming all of the above is correct, I'm very tempted to rip out .change_pte()
entirely. It's been dead weight for 8+ years and no one has complained about
KSM+KVM performance (I'd also be curious to know how much performance was gained
by shaving VM-Exits). As KVM is the only user of .change_pte(), dropping it in
KVM would mean the entire MMU notifier could also go away.

\
 
 \ /
  Last update: 2021-03-31 18:22    [W:0.064 / U:0.560 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site