lkml.org 
[lkml]   [2021]   [Mar]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v4 3/4] locking/qspinlock: Add ARCH_USE_QUEUED_SPINLOCKS_XCHG32
On Tue, Mar 30, 2021 at 7:56 AM Guo Ren <guoren@kernel.org> wrote:
>
> On Mon, Mar 29, 2021 at 9:56 PM Arnd Bergmann <arnd@arndb.de> wrote:
> >
> > On Mon, Mar 29, 2021 at 2:52 PM Guo Ren <guoren@kernel.org> wrote:
> > >
> > > On Mon, Mar 29, 2021 at 7:31 PM Peter Zijlstra <peterz@infradead.org> wrote:
> > > >
> > > > On Mon, Mar 29, 2021 at 01:16:53PM +0200, Peter Zijlstra wrote:
> > > > > Anyway, an additional 'funny' is that I suspect you cannot prove fwd
> > > > > progress of the entire primitive with any of this on. But who cares
> > > > > about details anyway.. :/
> > > >
> > > > What's the architectural guarantee on LL/SC progress for RISC-V ?
> > >
> > > funct5 | aq | rl | rs2 | rs1 | funct3 | rd | opcode
> > > 5 1 1 5 5 3 5 7
> > > LR.W/D ordering 0 addr width dest AMO
> > > SC.W/D ordering src addr width dest AMO
> > >
> > > LR.W loads a word from the address in rs1, places the sign-extended
> > > value in rd, and registers a reservation set—a set of bytes that
> > > subsumes the bytes in the addressed word. SC.W conditionally writes a
> > > word in rs2 to the address in rs1: the SC.W succeeds only if the
> > > reservation is still valid and the reservation set contains the bytes
> > > being written. If the SC.W succeeds, the instruction writes the word
> > > in rs2 to memory, and it writes zero to rd. If the SC.W fails, the
> > > instruction does not write to memory, and it writes a nonzero value to
> > > rd. Regardless of success or failure, executing an SC.W instruction
> > > *invalidates any reservation held by this hart*.
> > >
> > > More details, ref:
> > > https://github.com/riscv/riscv-isa-manual
> >
> > I think section "3.5.3.2 Reservability PMA" [1] would be a more relevant
> > link, as this defines memory areas that either do or do not have
> > forward progress guarantees, including this part:
> >
> > "When LR/SC is used for memory locations marked RsrvNonEventual,
> > software should provide alternative fall-back mechanisms used when
> > lack of progress is detected."
> >
> > My reading of this is that if the example you tried stalls, then either
> > the PMA is not RsrvEventual, and it is wrong to rely on ll/sc on this,
> > or that the PMA is marked RsrvEventual but the implementation is
> > buggy.
> Yes, PMA just defines physical memory region attributes, But in our
> processor, when MMU is enabled (satp's value register > 2) in s-mode,
> it will look at our custom PTE's attributes BIT(63) ref [1]:
>
> PTE format:
> | 63 | 62 | 61 | 60 | 59 | 58-8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0
> SO C B SH SE RSW D A G U X W R V
> ^ ^ ^ ^ ^
> BIT(63): SO - Strong Order
> BIT(62): C - Cacheable
> BIT(61): B - Bufferable
> BIT(60): SH - Shareable
> BIT(59): SE - Security
>
> So the memory also could be RsrvNone/RsrvEventual.
>
> [1] https://github.com/c-sky/csky-linux/commit/e837aad23148542771794d8a2fcc52afd0fcbf88

Is this about your C-sky architecture or your RISC-V implementation.

If these PTE bits are in your RISC-V implementation then clearly your
RISC-V implementation is not compliant with the RISC-V privilege spec
because these bits are not defined in RISC-V privilege spec.

Regards,
Anup
>
> >
> > It also seems that the current "amoswap" based implementation
> > would be reliable independent of RsrvEventual/RsrvNonEventual.
> Yes, the hardware implementation of AMO could be different from LR/SC.
> AMO could use ACE snoop holding to lock the bus in hw coherency
> design, but LR/SC uses an exclusive monitor without locking the bus.
>
> > arm64 is already in the situation of having to choose between
> > two cmpxchg() implementation at runtime to allow falling back to
> > a slower but more general version, but it's best to avoid that if you
> > can.
> Current RISC-V needn't multiple versions to select, and all AMO &
> LR/SC has been defined in the spec.
>
> RISC-V hasn't CAS instructions, and it uses LR/SC for cmpxchg. I don't
> think LR/SC would be slower than CAS, and CAS is just good for code
> size.
>
> >
> > Arnd
> >
> > [1] http://www.five-embeddev.com/riscv-isa-manual/latest/machine.html#atomicity-pmas
>
> --
> Best Regards
> Guo Ren
>
> ML: https://lore.kernel.org/linux-csky/

\
 
 \ /
  Last update: 2021-03-30 07:52    [W:0.114 / U:3.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site