lkml.org 
[lkml]   [2021]   [Mar]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 0/6] spi: Add OSPI PHY calibration support for spi-cadence-quadspi
Am 2021-03-12 11:10, schrieb Pratyush Yadav:
> There is usually a delay from when the flash drives the data line (IOW,
> puts a data bit on it) and when the signal reaches the controller. This
> delay can vary by the flash, board, silicon characteristics,
> temperature, etc.

Temperature might change over time, but the calibration is only done
once. I don't know how much influence the temperature actually has, but
our boards are usually operating from -40°C to +85°C. So there might be
a possible temperature difference of 125K between actual calibration and
when the flash is accessed.

-michael

\
 
 \ /
  Last update: 2021-03-12 11:21    [W:0.098 / U:2.312 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site