lkml.org 
[lkml]   [2021]   [Mar]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 11/11] pwm: Add Raspberry Pi Firmware based PWM bus
From
Date
On Thu, 2021-03-11 at 14:18 +0100, Uwe Kleine-König wrote:
> Hello Nicolas,
>
> On Thu, Mar 11, 2021 at 02:01:00PM +0100, Nicolas Saenz Julienne wrote:
> > On Wed, 2021-03-10 at 12:50 +0100, Uwe Kleine-König wrote:
> > > On Mon, Jan 18, 2021 at 01:32:44PM +0100, Nicolas Saenz Julienne wrote:
> >
> > [...]
> >
> > > > + /*
> > > > + * This sets the default duty cycle after resetting the board, we
> > > > + * updated it every time to mimic Raspberry Pi's downstream's driver
> > > > + * behaviour.
> > > > + */
> > > > + ret = raspberrypi_pwm_set_property(rpipwm->firmware, RPI_PWM_DEF_DUTY_REG,
> > > > + duty_cycle);
> > > > + if (ret) {
> > > > + dev_err(chip->dev, "Failed to set default duty cycle: %pe\n",
> > > > + ERR_PTR(ret));
> > > > + return ret;
> > >
> > > This only has an effect for the next reboot, right?
> >
> > It effects all reboots until it's further changed.
> >
> > > If so I wonder if it is a good idea in general. (Think: The current PWM
> > > setting enables a motor that makes a self-driving car move at 100 km/h.
> > > Consider the rpi crashes, do I want to car to pick up driving 100 km/h at
> > > power up even before Linux is up again?)
> >
> > I get your point. But this isn't used as a general purpose PWM. For now the
> > interface is solely there to drive a PWM fan that's arguably harmless. This
> > doesn't mean that the RPi foundation will not reuse the firmware interface for
> > other means in the future. In such case we can always use a new DT compatible
> > and bypass this feature (the current DT string is
> > 'raspberrypi,firmware-poe-pwm', which is specific to this use-case).
> >
> > My aim here is to be on par feature wise with RPi's downstream implementation.
>
> Just because the downstream kernel does it should not be the (single)
> reason to do that. My gut feeling is: For a motor restoring the PWM
> config on reboot is bad and for a fan it doesn't really hurt if it
> doesn't restart automatically. So I'd prefer to to drop this feature.

Fair enough, I'll remove it then.

Regards,
Nicolas

[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2021-03-11 14:43    [W:0.041 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site