lkml.org 
[lkml]   [2021]   [Feb]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectRe: [PATCH net v1 3/3] net: phy: mscc: coma mode disabled for VSC8514
Date
On Fri, Feb 12, 2021 at 03:06:43PM +0100, Bjarni Jonasson wrote:
> The 'coma mode' (configurable through sw or hw) provides an
> optional feature that may be used to control when the PHYs become active.
> The typical usage is to synchronize the link-up time across
> all PHY instances. This patch releases coma mode if not done by hardware,
> otherwise the phys will not link-up.
>
> Signed-off-by: Steen Hegelund <steen.hegelund@microchip.com>
> Signed-off-by: Bjarni Jonasson <bjarni.jonasson@microchip.com>
> Fixes: e4f9ba642f0b ("net: phy: mscc: add support for VSC8514 PHY.")
> ---
> drivers/net/phy/mscc/mscc_main.c | 13 +++++++++++++
> 1 file changed, 13 insertions(+)
>
> diff --git a/drivers/net/phy/mscc/mscc_main.c b/drivers/net/phy/mscc/mscc_main.c
> index 7546d9cc3abd..0600b592618b 100644
> --- a/drivers/net/phy/mscc/mscc_main.c
> +++ b/drivers/net/phy/mscc/mscc_main.c
> @@ -1418,6 +1418,18 @@ static void vsc8584_get_base_addr(struct phy_device *phydev)
> vsc8531->addr = addr;
> }
>
> +static void vsc85xx_coma_mode_release(struct phy_device *phydev)
> +{
> + /* The coma mode (pin or reg) provides an optional feature that
> + * may be used to control when the PHYs become active.
> + * Alternatively the COMA_MODE pin may be connected low
> + * so that the PHYs are fully active once out of reset.
> + */
> + __phy_write(phydev, MSCC_EXT_PAGE_ACCESS, MSCC_PHY_PAGE_EXTENDED_GPIO);
> + __phy_write(phydev, MSCC_PHY_GPIO_CONTROL_2, 0x0600);
> + __phy_write(phydev, MSCC_EXT_PAGE_ACCESS, MSCC_PHY_PAGE_STANDARD);

Can you please do:
phy_write_paged(phydev, MSCC_PHY_PAGE_EXTENDED_GPIO,
MSCC_PHY_GPIO_CONTROL_2, 0x0600);

And can you please provide some definitions for what 0x0600 is?
My reference manual says that:

Bit 13:
COMA_MODE output enable (active low)
Bit 12:
COMA_MODE output data
Bit 11:
COMA_MODE input data
Bit 10:
Reserved
Bit 9:
Tri-state enable for LEDs

0x600 is BIT(10) | BIT(9). But BIT(10) is reserved. Sure this is correct?

> +}
> +
> static int vsc8584_config_init(struct phy_device *phydev)
> {
> struct vsc8531_private *vsc8531 = phydev->priv;
> @@ -2610,6 +2622,7 @@ static int vsc8514_config_init(struct phy_device *phydev)
> ret = vsc8514_config_host_serdes(phydev);
> if (ret)
> goto err;
> + vsc85xx_coma_mode_release(phydev);
> }
>
> phy_unlock_mdio_bus(phydev);
> --
> 2.17.1
>
\
 
 \ /
  Last update: 2021-02-12 17:37    [W:0.104 / U:1.968 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site