lkml.org 
[lkml]   [2021]   [Dec]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectRe: [PATCH] mmc: bus: Log bus width info when attaching card
Date
Might seem unecessary to print the bus width and a bit confusing, but it is the only 'bus info' that is not printed in that line.
So I suggest adding it.

Regards,
Christian




From: Christian Löhle
Sent: Wednesday, December 8, 2021 2:02 PM
To: linux-kernel@vger.kernel.org; linux-mmc@vger.kernel.org; Ulf Hansson; Christian Löhle
Cc: johan@kernel.org; sudeep.holla@arm.com; linux@dominikbrodowski.net
Subject: [PATCH] mmc: bus: Log bus width info when attaching card
 
Add info about bus width of the attached card to the bring-up message

For both MMC and SD cards the bus width that is used might
not be obvious to a user. For MMC this might be 1, 4 or 8,
for SD only 1 and 4. In both cases this would be a restriction
by the host (setup). Like using an MMC in an SD slot or an
eMMC to SD adapter.

Signed-off-by: Christian Loehle <cloehle@hyperstone.com>
---
 drivers/mmc/core/bus.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/core/bus.c b/drivers/mmc/core/bus.c
index f6b7a9c5bbff..71a675dcd9b7 100644
--- a/drivers/mmc/core/bus.c
+++ b/drivers/mmc/core/bus.c
@@ -358,7 +358,7 @@ int mmc_add_card(struct mmc_card *card)
                         mmc_card_ddr52(card) ? "DDR " : "",
                         type);
         } else {
-               pr_info("%s: new %s%s%s%s%s%s card at address %04x\n",
+               pr_info("%s: new %s%s%s%s%s%s %u-bit card at address %04x\n",
                         mmc_hostname(card->host),
                         mmc_card_uhs(card) ? "ultra high speed " :
                         (mmc_card_hs(card) ? "high speed " : ""),
@@ -366,7 +366,8 @@ int mmc_add_card(struct mmc_card *card)
                         (mmc_card_hs200(card) ? "HS200 " : ""),
                         mmc_card_hs400es(card) ? "Enhanced strobe " : "",
                         mmc_card_ddr52(card) ? "DDR " : "",
-                       uhs_bus_speed_mode, type, card->rca);
+                       uhs_bus_speed_mode, type,
+                       1<<card->host->ios.bus_width, card->rca);
         }
 
 #ifdef CONFIG_DEBUG_FS
--
2.34.1
=
Hyperstone GmbH | Reichenaustr. 39a | 78467 Konstanz
Managing Director: Dr. Jan Peter Berns.
Commercial register of local courts: Freiburg HRB381782

\
 
 \ /
  Last update: 2021-12-08 14:05    [W:0.062 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site