lkml.org 
[lkml]   [2021]   [Dec]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v7 1/2] wilc1000: Add reset/enable GPIO support to SPI driver
From
Date
David Mosberger-Tang <davidm@egauge.net> wrote:

> For the SDIO driver, the RESET/ENABLE pins of WILC1000 are controlled
> through the SDIO power sequence driver. This commit adds analogous
> support for the SPI driver. Specifically, during initialization, the
> chip will be ENABLEd and taken out of RESET and during
> deinitialization, the chip will be placed back into RESET and disabled
> (both to reduce power consumption and to ensure the WiFi radio is
> off).
>
> Both RESET and ENABLE GPIOs are optional. However, if the ENABLE GPIO
> is specified, then the RESET GPIO should normally also be specified as
> otherwise there is no way to ensure proper timing of the ENABLE/RESET
> sequence.
>
> Signed-off-by: David Mosberger-Tang <davidm@egauge.net>
> Reviewed-by: Claudiu Beznea <claudiu.beznea@microchip.com>

2 patches applied to wireless-drivers-next.git, thanks.

ec031ac4792c wilc1000: Add reset/enable GPIO support to SPI driver
f31ee3c0a555 wilc1000: Document enable-gpios and reset-gpios properties

--
https://patchwork.kernel.org/project/linux-wireless/patch/20211221212531.4011609-2-davidm@egauge.net/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches

\
 
 \ /
  Last update: 2021-12-22 18:52    [W:0.058 / U:0.236 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site