lkml.org 
[lkml]   [2021]   [Dec]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v6 1/2] wilc1000: Add reset/enable GPIO support to SPI driver
From
Date
David Mosberger-Tang <davidm@egauge.net> wrote:

> For the SDIO driver, the RESET/ENABLE pins of WILC1000 are controlled
> through the SDIO power sequence driver. This commit adds analogous
> support for the SPI driver. Specifically, during initialization, the
> chip will be ENABLEd and taken out of RESET and during
> deinitialization, the chip will be placed back into RESET and disabled
> (both to reduce power consumption and to ensure the WiFi radio is
> off).
>
> Both RESET and ENABLE GPIOs are optional. However, if the ENABLE GPIO
> is specified, then the RESET GPIO should normally also be specified as
> otherwise there is no way to ensure proper timing of the ENABLE/RESET
> sequence.
>
> Signed-off-by: David Mosberger-Tang <davidm@egauge.net>

Failed to apply, please rebase on top of wireless-drivers-next.

error: sha1 information is lacking or useless (drivers/net/wireless/microchip/wilc1000/wlan.c).
error: could not build fake ancestor
hint: Use 'git am --show-current-patch' to see the failed patch
Applying: wilc1000: Add reset/enable GPIO support to SPI driver
Patch failed at 0001 wilc1000: Add reset/enable GPIO support to SPI driver

2 patches set to Changes Requested.

12688345 [v6,1/2] wilc1000: Add reset/enable GPIO support to SPI driver
12688343 [v6,2/2] wilc1000: Document enable-gpios and reset-gpios properties

--
https://patchwork.kernel.org/project/linux-wireless/patch/20211220180334.3990693-2-davidm@egauge.net/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches

\
 
 \ /
  Last update: 2021-12-21 19:12    [W:0.064 / U:0.632 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site