Messages in this thread | | | From | Song Liu <> | Date | Fri, 17 Dec 2021 09:25:25 -0800 | Subject | Re: [PATCH v3] lib/raid6: Reduce high latency by using migrate instead of preempt |
| |
On Fri, Dec 17, 2021 at 5:42 AM Sebastian Andrzej Siewior <bigeasy@linutronix.de> wrote: > > On 2021-12-17 10:16:10 [+0800], Yajun Deng wrote: > > We found an abnormally high latency when executing modprobe raid6_pq, the > > latency is greater than 1.2s when CONFIG_PREEMPT_VOLUNTARY=y, greater than > > 67ms when CONFIG_PREEMPT=y, and greater than 16ms when CONFIG_PREEMPT_RT=y. > > > > How to reproduce: > > - Install cyclictest > > sudo apt install rt-tests > > - Run cyclictest example in one terminal > > sudo cyclictest -S -p 95 -d 0 -i 1000 -D 24h -m > > - Modprobe raid6_pq in another terminal > > sudo modprobe raid6_pq > > > > This is caused by ksoftirqd fail to scheduled due to disable preemption, > > this time is too long and unreasonable. > > > > Reduce high latency by using migrate_disabl()/emigrate_enable() instead of > > preempt_disable()/preempt_enable(), the latency won't greater than 100us. > > > > This patch beneficial for CONFIG_PREEMPT=y or CONFIG_PREEMPT_RT=y, but no > > effect for CONFIG_PREEMPT_VOLUNTARY=y. > > Why does it matter? This is only during boot-up/ module loading or do I > miss something?
Yes this only happens on boot-up and module loading.I don't know RT well enough to tell whether latency during module loading is an issue.
> The delay is a jiffy so it depends on CONFIG_HZ. You do benchmark for > the best algorithm and if you get preempted during that period then your > results may be wrong and you make a bad selection.
With current code, the delay _should be_ 16 jiffies. However, the experiment hits way longer latencies. I agree this may cause inaccurate benchmark results and thus suboptimal RAID algorithm.
I guess the key question is whether long latency at module loading time matters. If that doesn't matter, we should just drop this.
Thanks, Song
| |