Messages in this thread | | | Date | Thu, 16 Dec 2021 16:17:21 +0000 | From | Dave Allerton <> | Subject | ThrustMaster USB interface question |
| |
Hi I have interfaced ThrustMaster controls via 3 USP ports on a Raspberry Pi.
Everything works fine, except that initially, the digital inputs are all zero (OFF), even though a switch may be set in the non-zero position (ON). If a switch starts in a non-zero position (ON), to read the correct value I have to flick the switch off and then on. Is there any way to read the positions of all the digital inputs initially?
Many thanks
-- Dave
===================================================== David Allerton BSc,PhD,PGCE,CEng,FIEE Emeritus Professor of Computer Systems Engineering Department of Automatic Control & Systems Engineering University of Sheffield Mappin St Sheffield S1 3JD
Visiting Professor Cranfield University Honorary Consultant CnTech Co. Ltd Managing Director Aerosoft Ltd
phone +44 (0) 7754-486866 email d.j.allerton@sheffield.ac.uk book http://www.wiley.com/legacy/wileychi/allerton =====================================================
| |