[lkml]   [2021]   [Dec]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH] ASoC: max98357a: Add mixer control to mute/unmute speaker
On Thu, Dec 16, 2021 at 05:54:45PM +0530, Ajit Kumar Pandey wrote:

> Thanks for suggestion. We tried using SND_SOC_DAPM_PIN_SWITCH() for the
> speaker widget and it invoke dapm_event callback based on switch i.e
> max98357a_sdmode_event() but codec driver isn't enabling/disabling gpios in
> such event callback instead they are doing that in dai_ops trigger callback.
> In our platform single I2S controller instance (cpu-dai) is connected to two
> different endpoints with a single PCM device, hence we want to switch or
> enable/disable output based on Machine driver controls only.

DAPM should cope perfectly fine with this setup...

> Initially we thought to configure gpio within sdmode_event callback but
> there was some pop noise issue reported in one platform with that change
> hence reverted. Check
> So we thought of exposing a mixer control to enable/disable amp from UCM
> in our platform without breaking existing functionality. Please let us
> know any other alternative way if possible.

Whatever is going on this should be managed from the driver rather than
having a direct control, especially given the issues I mentioned with
there being zero coordination between this and the management that the
driver already does. You could have DAPM controls set a variable and
coordinate with whatever you're doing in the pcm_ops, I'm not clear what
the use case is for having the manual control TBH.
[unhandled content-type:application/pgp-signature]
 \ /
  Last update: 2021-12-16 14:31    [W:0.113 / U:0.480 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site