lkml.org 
[lkml]   [2021]   [Nov]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v2 2/2] dax,pmem: Implement pmem based dax data recovery
Date
On 11/9/2021 10:48 AM, Dan Williams wrote:
> On Mon, Nov 8, 2021 at 11:27 PM Christoph Hellwig <hch@infradead.org> wrote:
>>
>> On Fri, Nov 05, 2021 at 07:16:38PM -0600, Jane Chu wrote:
>>> static size_t pmem_copy_from_iter(struct dax_device *dax_dev, pgoff_t pgoff,
>>> void *addr, size_t bytes, struct iov_iter *i, int mode)
>>> {
>>> + phys_addr_t pmem_off;
>>> + size_t len, lead_off;
>>> + struct pmem_device *pmem = dax_get_private(dax_dev);
>>> + struct device *dev = pmem->bb.dev;
>>> +
>>> + if (unlikely(mode == DAX_OP_RECOVERY)) {
>>> + lead_off = (unsigned long)addr & ~PAGE_MASK;
>>> + len = PFN_PHYS(PFN_UP(lead_off + bytes));
>>> + if (is_bad_pmem(&pmem->bb, PFN_PHYS(pgoff) / 512, len)) {
>>> + if (lead_off || !(PAGE_ALIGNED(bytes))) {
>>> + dev_warn(dev, "Found poison, but addr(%p) and/or bytes(%#lx) not page aligned\n",
>>> + addr, bytes);
>>> + return (size_t) -EIO;
>>> + }
>>> + pmem_off = PFN_PHYS(pgoff) + pmem->data_offset;
>>> + if (pmem_clear_poison(pmem, pmem_off, bytes) !=
>>> + BLK_STS_OK)
>>> + return (size_t) -EIO;
>>> + }
>>> + }
>>
>> This is in the wrong spot. As seen in my WIP series individual drivers
>> really should not hook into copying to and from the iter, because it
>> really is just one way to write to a nvdimm. How would dm-writecache
>> clear the errors with this scheme?
>>
>> So IMHO going back to the separate recovery method as in your previous
>> patch really is the way to go. If/when the 64-bit store happens we
>> need to figure out a good way to clear the bad block list for that.
>
> I think we just make error management a first class citizen of a
> dax-device and stop abstracting it behind a driver callback. That way
> the driver that registers the dax-device can optionally register error
> management as well. Then fsdax path can do:
>
> rc = dax_direct_access(..., &kaddr, ...);
> if (unlikely(rc)) {
> kaddr = dax_mk_recovery(kaddr);

Sorry, what does dax_mk_recovery(kaddr) do?

> dax_direct_access(..., &kaddr, ...);
> return dax_recovery_{read,write}(..., kaddr, ...);
> }
> return copy_{mc_to_iter,from_iter_flushcache}(...);
>
> Where, the recovery version of dax_direct_access() has the opportunity
> to change the page permissions / use an alias mapping for the access,

again, sorry, what 'page permissions'? memory_failure_dev_pagemap()
changes the poisoned page mem_type from 'rw' to 'uc-' (should be NP?),
do you mean to reverse the change?

> dax_recovery_read() allows reading the good cachelines out of a
> poisoned page, and dax_recovery_write() coordinates error list
> management and returning a poison page to full write-back caching
> operation when no more poisoned cacheline are detected in the page.
>

How about to introduce 3 dax_recover_ APIs:
dax_recover_direct_access(): similar to dax_direct_access except
it ignores error list and return the kaddr, and hence is also
optional, exported by device driver that has the ability to
detect error;
dax_recovery_read(): optional, supported by pmem driver only,
reads as much data as possible up to the poisoned page;
dax_recovery_write(): optional, supported by pmem driver only,
first clear-poison, then write.

Should we worry about the dm targets?

Both dax_recovery_read/write() are hooked up to dax_iomap_iter().

Thanks,
-jane



\
 
 \ /
  Last update: 2021-11-09 21:00    [W:0.855 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site