lkml.org 
[lkml]   [2021]   [Nov]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC v4 5/6] mmc: core: transplant ti,wl1251 quirks from to be retired omap_hsmmc
From
Date


> Am 08.11.2021 um 16:33 schrieb Ulf Hansson <ulf.hansson@linaro.org>:
>
> On Fri, 5 Nov 2021 at 10:06, H. Nikolaus Schaller <hns@goldelico.com> wrote:
>>
>> The TiWi WL1251 WiFi chip needs special setup of the sdio
>> interface before it can be probed.
>>
>> So far, this is done in omap_hsmmc_init_card() in omap_hsmmc.c
>> which makes it useable only if connected to omap devices
>> which use the omap_hsmmc. The OpenPandora is the most promient
>> example.
>>
>> There are plans to switch to a newer sdhci-omap driver and
>> retire omap_hsmmc. Hence this quirk must be reworked or moved
>> somewhere else. Ideally to some location that is not dependent
>> on the specific SoC mmc host driver.
>>
>> This is achieved by the new mmc_fixup_device() option introduced
>> by ("mmc: allow to match the device tree to apply quirks") to match
>> through device tree compatible string.
>>
>> This quirk will be called early right after where host->ops->init_card()
>> and thus omap_hsmmc_init_card() was previously called.
>>
>> Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
>> ---
>> drivers/mmc/core/card.h | 19 +++++++++++++++++++
>> drivers/mmc/core/quirks.h | 7 +++++++
>> 2 files changed, 26 insertions(+)
>>
>> diff --git a/drivers/mmc/core/card.h b/drivers/mmc/core/card.h
>> index 089ede71d3150..20c8dfd6831cf 100644
>> --- a/drivers/mmc/core/card.h
>> +++ b/drivers/mmc/core/card.h
>> @@ -168,6 +168,25 @@ static inline void __maybe_unused add_limit_rate_quirk(struct mmc_card *card,
>> card->quirk_max_rate = data;
>> }
>>
>> +static inline void __maybe_unused wl1251_quirk(struct mmc_card *card,
>> + int data)
>> +{
>> + /*
>> + * We have TI wl1251 attached to this mmc. Pass this
>> + * information to the SDIO core because it can't be
>> + * probed by normal methods.
>> + */
>> +
>> + dev_info(card->host->parent, "found wl1251\n");
>> + card->quirks |= MMC_QUIRK_NONSTD_SDIO;
>> + card->cccr.wide_bus = 1;
>> + card->cis.vendor = 0x104c;
>> + card->cis.device = 0x9066;
>> + card->cis.blksize = 512;
>> + card->cis.max_dtr = 24000000;
>> + card->ocr = 0x80;
>
> In the past, we discussed a bit around why card->ocr needs to be set here.
>
> The reason could very well be that the DTS file is specifying the
> vmmc-supply with 1.8V fixed regulator, which seems wrong to me.
>
> I would be very interested to know if we would change
> "regulator-min|max-microvolt" of the regulator in the DTS, into
> somewhere in between 2700000-3600000 (2.7-3.6V) - and see if that
> allows us to drop the assignment of "card->ocr = 0x80;" above. Would
> you mind doing some tests for this?
>
> If that works, we should add some comments about it above, I think.

Will try before posting next version [PATCH v1].

\
 
 \ /
  Last update: 2021-11-08 17:08    [W:0.123 / U:0.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site