lkml.org 
[lkml]   [2021]   [Nov]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 11/15] iio: buffer-dma: Boost performance using write-combine cache setting
From
Date
On 11/27/21 5:05 PM, Jonathan Cameron wrote:
>> Non-coherent mapping with no cache sync:
>> - fileio:
>> read: 156 MiB/s
>> write: 123 MiB/s
>> - dmabuf:
>> read: 234 MiB/s (capped by sample rate)
>> write: 182 MiB/s
>>
>> Non-coherent reads with no cache sync + write-combine writes:
>> - fileio:
>> read: 156 MiB/s
>> write: 140 MiB/s
>> - dmabuf:
>> read: 234 MiB/s (capped by sample rate)
>> write: 210 MiB/s
>>
>>
>> A few things we can deduce from this:
>>
>> * Write-combine is not available on Zynq/ARM? If it was working, it
>> should give a better performance than the coherent mapping, but it
>> doesn't seem to do anything at all. At least it doesn't harm
>> performance.
> I'm not sure it's very relevant to this sort of streaming write.
> If you write a sequence of addresses then nothing stops them getting combined
> into a single write whether or not it is write-combining.

There is a difference at which point they can get combined. With
write-combine they can be coalesced into a single transaction anywhere
in the interconnect, as early as the CPU itself. Without write-cobmine
the DDR controller might decide to combine them, but not earlier. This
can make a difference especially if the write is a narrow write, i.e.
the access size is smaller than the buswidth.

Lets say you do 32-bit writes, but your bus is 64 bits wide. With WC two
32-bits can be combined into a 64-bit write. Without WC that is not
possible and you are potentially not using the bus to its fullest
capacity. This is especially true if the memory bus is wider than the
widest access size of the CPU.


\
 
 \ /
  Last update: 2021-11-28 14:28    [W:0.118 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site