lkml.org 
[lkml]   [2021]   [Nov]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC v2] mac80211: minstrel_ht: do not set RTS/CTS flag for fallback rates
Hello Felix,

On Fri, 26 Nov 2021 13:47:07 +0100, Felix Fietkau <nbd@nbd.name> wrote:

> On 2021-11-16 22:28, Peter Seiderer wrote:
> > Despite the 'RTS thr:off' setting a wireshark trace of IBSS
> > traffic with HT40 mode enabled between two ath9k cards revealed
> > some RTS/CTS traffic.
> >
> > Debug and code analysis showed that most places setting
> > IEEE80211_TX_RC_USE_RTS_CTS respect the RTS strategy by
> > evaluating rts_threshold, e.g. net/mac80211/tx.c:
> >
> > 698 /* set up RTS protection if desired */
> > 699 if (len > tx->local->hw.wiphy->rts_threshold) {
> > 700 txrc.rts = true;
> > 701 }
> > 702
> > 703 info->control.use_rts = txrc.rts;
> >
> > or drivers/net/wireless/ath/ath9k/xmit.c
> >
> > 1238 /*
> > 1239 * Handle RTS threshold for unaggregated HT frames.
> > 1240 */
> > 1241 if (bf_isampdu(bf) && !bf_isaggr(bf) &&
> > 1242 (rates[i].flags & IEEE80211_TX_RC_MCS) &&
> > 1243 unlikely(rts_thresh != (u32) -1)) {
> > 1244 if (!rts_thresh || (len > rts_thresh))
> > 1245 rts = true;
> > 1246 }
> >
> > The only place setting IEEE80211_TX_RC_USE_RTS_CTS unconditionally
> > was found in net/mac80211/rc80211_minstrel_ht.c.
> >
> > As the use_rts value is only calculated after hitting the minstrel_ht code
> > preferre to not set IEEE80211_TX_RC_USE_RTS_CTS (and overruling the
> > RTS threshold setting) for the fallback rates case.
> The idea behind the this part of minstrel_ht code is to avoid the
> overhead of RTS/CTS for transmissions using the primary rate and to
> increase the reliability of retransmissions by adding it for fallback
> rates. This is completely unrelated to the RTS threshold.

How does it avoid RTS/CTS (if it is set independent by RTS threshold
evaluation mac80211 and/or hardware driver)?

>
> If you don't want this behavior, I'm fine with adding a way to
> explicitly disable it. However, I do think leaving it on by default
> makes sense.

I expected this (as otherwise the flag setting would not be there) ;-)

Any hint how to implement an additional RTS/CTS on/off feature despite
the RTS threshold one for use explicit by minstrel_ht? Configure option,
module option, ...?

Regards,
Peter

>
> - Felix

\
 
 \ /
  Last update: 2021-11-26 15:29    [W:0.060 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site