lkml.org 
[lkml]   [2021]   [Nov]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [RFC PATCH v1] Bluetooth: hci_qca: Add new hci_uart proto callback to power off voltage sources
From
Date
Hi,

> This change adds a new hci_uart proto callback entry i.e., power off.
> This poweroff Callback is exposed to the drivers and called during BT OFF
> immediately after port close. This will ensure that Voltages sources are
> powered off after sending all the data before port close. Previously as
> part of hdev shutdown callback, voltages sources are powered off. But we
> have seen cases where post shutdown sequence completion some packets which
> are already queued are sent to UART. As controller is powered off, UART
> can’t send the data out or it is sending partial data due RTS line high.
>
> Signed-off-by: saluvala <saluvala@codeaurora.org>

this really has to stop. Read the documentation on how to submit patches and start configuring your .gitconfig correct so that you include you clear text name etc.

> ---
> drivers/bluetooth/hci_qca.c | 26 +++++++++++++++++++-------
> drivers/bluetooth/hci_serdev.c | 3 +++
> drivers/bluetooth/hci_uart.h | 1 +
> 3 files changed, 23 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
> index dd768a8..e1dee75 100644
> --- a/drivers/bluetooth/hci_qca.c
> +++ b/drivers/bluetooth/hci_qca.c
> @@ -231,6 +231,7 @@ static int qca_regulator_enable(struct qca_serdev *qcadev);
> static void qca_regulator_disable(struct qca_serdev *qcadev);
> static void qca_power_shutdown(struct hci_uart *hu);
> static int qca_power_off(struct hci_dev *hdev);
> +static int qca_power_off_reg(struct hci_uart *hu);
> static void qca_controller_memdump(struct work_struct *work);
>
> static enum qca_btsoc_type qca_soc_type(struct hci_uart *hu)
> @@ -554,7 +555,6 @@ static void qca_controller_memdump_timeout(struct work_struct *work)
> mutex_unlock(&qca->hci_memdump_lock);
> }
>
> -
> /* Initialize protocol */
> static int qca_open(struct hci_uart *hu)
> {
> @@ -1815,6 +1815,7 @@ static const struct hci_uart_proto qca_proto = {
> .flush = qca_flush,
> .setup = qca_setup,
> .recv = qca_recv,
> + .poweroff = qca_power_off_reg,
> .enqueue = qca_enqueue,
> .dequeue = qca_dequeue,
> };

I am not extending this. Write a clean serdev only driver for this hardware.

Regards

Marcel

\
 
 \ /
  Last update: 2021-11-25 19:49    [W:0.043 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site