lkml.org 
[lkml]   [2021]   [Nov]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v4 12/12] gpio: Add support for Airoha EN7523 GPIO controller
On Thu, Nov 25, 2021 at 12:24 PM Felix Fietkau <nbd@nbd.name> wrote:
>
> From: John Crispin <john@phrozen.org>
>
> Airoha's GPIO controller on their ARM EN7523 SoCs consists of two banks of 32
> GPIOs. Each instance in DT is for an single bank.
>
> Signed-off-by: John Crispin <john@phrozen.org>
> Signed-off-by: Felix Fietkau <nbd@nbd.name>
> ---
> arch/arm/boot/dts/en7523-evb.dts | 8 ++
> arch/arm/boot/dts/en7523.dtsi | 21 +++++
> drivers/gpio/Kconfig | 9 ++
> drivers/gpio/Makefile | 1 +
> drivers/gpio/gpio-en7523.c | 136 +++++++++++++++++++++++++++++++
> 5 files changed, 175 insertions(+)
> create mode 100644 drivers/gpio/gpio-en7523.c

These changes should be split into two separate patches. Other than
that the driver looks good.

>
> diff --git a/arch/arm/boot/dts/en7523-evb.dts b/arch/arm/boot/dts/en7523-evb.dts
> index af1a8dd40a41..4082bf61bd79 100644
> --- a/arch/arm/boot/dts/en7523-evb.dts
> +++ b/arch/arm/boot/dts/en7523-evb.dts
> @@ -37,3 +37,11 @@ &pcie0 {
> &pcie1 {
> status = "okay";
> };
> +
> +&gpio0 {
> + status = "okay";
> +};
> +
> +&gpio1 {
> + status = "okay";
> +};
> diff --git a/arch/arm/boot/dts/en7523.dtsi b/arch/arm/boot/dts/en7523.dtsi
> index d9bdb51614b5..6e0275984b69 100644
> --- a/arch/arm/boot/dts/en7523.dtsi
> +++ b/arch/arm/boot/dts/en7523.dtsi
> @@ -3,6 +3,7 @@
> #include <dt-bindings/interrupt-controller/irq.h>
> #include <dt-bindings/interrupt-controller/arm-gic.h>
> #include <dt-bindings/clock/en7523-clk.h>
> +#include <dt-bindings/gpio/gpio.h>
>
> / {
> interrupt-parent = <&gic>;
> @@ -120,6 +121,26 @@ uart1: serial@1fbf0000 {
> status = "okay";
> };
>
> + gpio0: gpio@1fbf0200 {
> + compatible = "airoha,en7523-gpio";
> + reg = <0x1fbf0204 0x4>,
> + <0x1fbf0200 0x4>,
> + <0x1fbf0220 0x4>,
> + <0x1fbf0214 0x4>;
> + gpio-controller;
> + #gpio-cells = <2>;
> + };
> +
> + gpio1: gpio@1fbf0270 {
> + compatible = "airoha,en7523-gpio";
> + reg = <0x1fbf0270 0x4>,
> + <0x1fbf0260 0x4>,
> + <0x1fbf0264 0x4>,
> + <0x1fbf0278 0x4>;
> + gpio-controller;
> + #gpio-cells = <2>;
> + };
> +
> pcie: pcie@1a140000 {
> compatible = "airoha,en7523-pcie", "mediatek,mt7622-pcie";
> device_type = "pci";
> diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
> index 072ed610f9c6..e4a34272504f 100644
> --- a/drivers/gpio/Kconfig
> +++ b/drivers/gpio/Kconfig
> @@ -247,6 +247,15 @@ config GPIO_EM
> help
> Say yes here to support GPIO on Renesas Emma Mobile SoCs.
>
> +config GPIO_EN7523
> + tristate "Airoha GPIO support"
> + depends on ARCH_AIROHA
> + default ARCH_AIROHA
> + select GPIO_GENERIC
> + select GPIOLIB_IRQCHIP
> + help
> + Say yes here to support the GPIO controller on Airoha EN7523.
> +
> config GPIO_EP93XX
> def_bool y
> depends on ARCH_EP93XX
> diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
> index 71ee9fc2ff83..d2269ee0948e 100644
> --- a/drivers/gpio/Makefile
> +++ b/drivers/gpio/Makefile
> @@ -56,6 +56,7 @@ obj-$(CONFIG_GPIO_DLN2) += gpio-dln2.o
> obj-$(CONFIG_GPIO_DWAPB) += gpio-dwapb.o
> obj-$(CONFIG_GPIO_EIC_SPRD) += gpio-eic-sprd.o
> obj-$(CONFIG_GPIO_EM) += gpio-em.o
> +obj-$(CONFIG_GPIO_EN7523) += gpio-en7523.o
> obj-$(CONFIG_GPIO_EP93XX) += gpio-ep93xx.o
> obj-$(CONFIG_GPIO_EXAR) += gpio-exar.o
> obj-$(CONFIG_GPIO_F7188X) += gpio-f7188x.o
> diff --git a/drivers/gpio/gpio-en7523.c b/drivers/gpio/gpio-en7523.c
> new file mode 100644
> index 000000000000..3ae0d9831d83
> --- /dev/null
> +++ b/drivers/gpio/gpio-en7523.c
> @@ -0,0 +1,136 @@
> +// SPDX-License-Identifier: GPL-2.0-only
> +
> +#include <linux/gpio/driver.h>
> +#include <linux/mod_devicetable.h>
> +#include <linux/module.h>
> +#include <linux/platform_device.h>
> +#include <linux/property.h>
> +
> +#define AIROHA_GPIO_MAX 32
> +
> +/**
> + * airoha_gpio_ctrl - Airoha GPIO driver data
> + *
> + * @gc: Associated gpio_chip instance.
> + * @data: The data register.
> + * @dir0: The direction register for the lower 16 pins.
> + * @dir1: The direction register for the lower 16 pins.
> + * @output: The output enable register.
> + */
> +struct airoha_gpio_ctrl {
> + struct gpio_chip gc;
> + void __iomem *data;
> + void __iomem *dir[2];
> + void __iomem *output;
> +};
> +
> +static struct airoha_gpio_ctrl *gc_to_ctrl(struct gpio_chip *gc)
> +{
> + return container_of(gc, struct airoha_gpio_ctrl, gc);
> +}
> +
> +static int airoha_dir_set(struct gpio_chip *gc, unsigned int gpio,
> + int val, int out)
> +{
> + struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> + u32 dir = ioread32(ctrl->dir[gpio / 16]);
> + u32 output = ioread32(ctrl->output);
> + u32 mask = BIT((gpio % 16) * 2);
> +
> + if (out) {
> + dir |= mask;
> + output |= BIT(gpio);
> + } else {
> + dir &= ~mask;
> + output &= ~BIT(gpio);
> + }
> +
> + iowrite32(dir, ctrl->dir[gpio / 16]);
> + iowrite32(output, ctrl->output);
> +
> + if (out)
> + gc->set(gc, gpio, val);
> +
> + return 0;
> +}

No locking needed here? gpio-mmio uses bgpio_lock from struct
gpio_chip, maybe you should take it here too?

Bart

> +
> +static int airoha_dir_out(struct gpio_chip *gc, unsigned int gpio,
> + int val)
> +{
> + return airoha_dir_set(gc, gpio, val, 1);
> +}
> +
> +static int airoha_dir_in(struct gpio_chip *gc, unsigned int gpio)
> +{
> + return airoha_dir_set(gc, gpio, 0, 0);
> +}
> +
> +static int airoha_get_dir(struct gpio_chip *gc, unsigned int gpio)
> +{
> + struct airoha_gpio_ctrl *ctrl = gc_to_ctrl(gc);
> + u32 dir = ioread32(ctrl->dir[gpio / 16]);
> + u32 mask = BIT((gpio % 16) * 2);
> +
> + return dir & mask;
> +}
> +
> +static const struct of_device_id airoha_gpio_of_match[] = {
> + { .compatible = "airoha,en7523-gpio" },
> + { }
> +};
> +MODULE_DEVICE_TABLE(of, airoha_gpio_of_match);
> +
> +static int airoha_gpio_probe(struct platform_device *pdev)
> +{
> + struct device *dev = &pdev->dev;
> + struct airoha_gpio_ctrl *ctrl;
> + int err;
> +
> + ctrl = devm_kzalloc(dev, sizeof(*ctrl), GFP_KERNEL);
> + if (!ctrl)
> + return -ENOMEM;
> +
> + ctrl->data = devm_platform_ioremap_resource(pdev, 0);
> + if (IS_ERR(ctrl->data))
> + return PTR_ERR(ctrl->data);
> +
> + ctrl->dir[0] = devm_platform_ioremap_resource(pdev, 1);
> + if (IS_ERR(ctrl->dir[0]))
> + return PTR_ERR(ctrl->dir[0]);
> +
> + ctrl->dir[1] = devm_platform_ioremap_resource(pdev, 2);
> + if (IS_ERR(ctrl->dir[1]))
> + return PTR_ERR(ctrl->dir[1]);
> +
> + ctrl->output = devm_platform_ioremap_resource(pdev, 3);
> + if (IS_ERR(ctrl->output))
> + return PTR_ERR(ctrl->output);
> +
> + err = bgpio_init(&ctrl->gc, dev, 4, ctrl->data, NULL,
> + NULL, NULL, NULL, 0);
> + if (err) {
> + dev_err(dev, "unable to init generic GPIO");
> + return err;
> + }
> +
> + ctrl->gc.ngpio = AIROHA_GPIO_MAX;
> + ctrl->gc.owner = THIS_MODULE;
> + ctrl->gc.direction_output = airoha_dir_out;
> + ctrl->gc.direction_input = airoha_dir_in;
> + ctrl->gc.get_direction = airoha_get_dir;
> +
> + return devm_gpiochip_add_data(dev, &ctrl->gc, ctrl);
> +}
> +
> +static struct platform_driver airoha_gpio_driver = {
> + .driver = {
> + .name = "airoha-gpio",
> + .of_match_table = airoha_gpio_of_match,
> + },
> + .probe = airoha_gpio_probe,
> +};
> +module_platform_driver(airoha_gpio_driver);
> +
> +MODULE_DESCRIPTION("Airoha GPIO support");
> +MODULE_AUTHOR("John Crispin <john@phrozen.org>");
> +MODULE_LICENSE("GPL v2");
> --
> 2.30.1
>

\
 
 \ /
  Last update: 2021-11-25 14:07    [W:3.210 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site