lkml.org 
[lkml]   [2021]   [Nov]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5.14 088/125] net: hns3: fix pause config problem after autoneg disabled
Date
From: Guangbin Huang <huangguangbin2@huawei.com>

commit 3bda2e5df476417b6d08967e2d84234a59d57b1c upstream.

If a TP port is configured by follow steps:
1.ethtool -s ethx autoneg off speed 100 duplex full
2.ethtool -A ethx rx on tx on
3.ethtool -s ethx autoneg on(rx&tx negotiated pause results are off)
4.ethtool -s ethx autoneg off speed 100 duplex full

In step 3, driver will set rx&tx pause parameters of hardware to off as
pause parameters negotiated with link partner are off.

After step 4, the "ethtool -a ethx" command shows both rx and tx pause
parameters are on. However, pause parameters of hardware are still off
and port has no flow control function actually.

To fix this problem, if autoneg is disabled, driver uses its saved
parameters to restore pause of hardware. If the speed is not changed in
this case, there is no link state changed for phy, it will cause the pause
parameter is not taken effect, so we need to force phy to go down and up.

Fixes: aacbe27e82f0 ("net: hns3: modify how pause options is displayed")
Signed-off-by: Guangbin Huang <huangguangbin2@huawei.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/net/ethernet/hisilicon/hns3/hnae3.h | 1
drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c | 33 +++++++++++-----
drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_main.c | 30 ++++++++++++++
drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c | 2
drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.h | 1
5 files changed, 57 insertions(+), 10 deletions(-)

--- a/drivers/net/ethernet/hisilicon/hns3/hnae3.h
+++ b/drivers/net/ethernet/hisilicon/hns3/hnae3.h
@@ -568,6 +568,7 @@ struct hnae3_ae_ops {
u32 *auto_neg, u32 *rx_en, u32 *tx_en);
int (*set_pauseparam)(struct hnae3_handle *handle,
u32 auto_neg, u32 rx_en, u32 tx_en);
+ int (*restore_pauseparam)(struct hnae3_handle *handle);

int (*set_autoneg)(struct hnae3_handle *handle, bool enable);
int (*get_autoneg)(struct hnae3_handle *handle);
--- a/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3_ethtool.c
@@ -838,6 +838,26 @@ static int hns3_check_ksettings_param(co
return 0;
}

+static int hns3_set_phy_link_ksettings(struct net_device *netdev,
+ const struct ethtool_link_ksettings *cmd)
+{
+ struct hnae3_handle *handle = hns3_get_handle(netdev);
+ const struct hnae3_ae_ops *ops = handle->ae_algo->ops;
+ int ret;
+
+ if (cmd->base.speed == SPEED_1000 &&
+ cmd->base.autoneg == AUTONEG_DISABLE)
+ return -EINVAL;
+
+ if (cmd->base.autoneg == AUTONEG_DISABLE && ops->restore_pauseparam) {
+ ret = ops->restore_pauseparam(handle);
+ if (ret)
+ return ret;
+ }
+
+ return phy_ethtool_ksettings_set(netdev->phydev, cmd);
+}
+
static int hns3_set_link_ksettings(struct net_device *netdev,
const struct ethtool_link_ksettings *cmd)
{
@@ -856,16 +876,11 @@ static int hns3_set_link_ksettings(struc
cmd->base.autoneg, cmd->base.speed, cmd->base.duplex);

/* Only support ksettings_set for netdev with phy attached for now */
- if (netdev->phydev) {
- if (cmd->base.speed == SPEED_1000 &&
- cmd->base.autoneg == AUTONEG_DISABLE)
- return -EINVAL;
-
- return phy_ethtool_ksettings_set(netdev->phydev, cmd);
- } else if (test_bit(HNAE3_DEV_SUPPORT_PHY_IMP_B, ae_dev->caps) &&
- ops->set_phy_link_ksettings) {
+ if (netdev->phydev)
+ return hns3_set_phy_link_ksettings(netdev, cmd);
+ else if (test_bit(HNAE3_DEV_SUPPORT_PHY_IMP_B, ae_dev->caps) &&
+ ops->set_phy_link_ksettings)
return ops->set_phy_link_ksettings(handle, cmd);
- }

if (ae_dev->dev_version < HNAE3_DEVICE_VERSION_V2)
return -EOPNOTSUPP;
--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_main.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_main.c
@@ -11014,6 +11014,35 @@ static int hclge_set_pauseparam(struct h
return -EOPNOTSUPP;
}

+static int hclge_restore_pauseparam(struct hnae3_handle *handle)
+{
+ struct hclge_vport *vport = hclge_get_vport(handle);
+ struct hclge_dev *hdev = vport->back;
+ u32 auto_neg, rx_pause, tx_pause;
+ int ret;
+
+ hclge_get_pauseparam(handle, &auto_neg, &rx_pause, &tx_pause);
+ /* when autoneg is disabled, the pause setting of phy has no effect
+ * unless the link goes down.
+ */
+ ret = phy_suspend(hdev->hw.mac.phydev);
+ if (ret)
+ return ret;
+
+ phy_set_asym_pause(hdev->hw.mac.phydev, rx_pause, tx_pause);
+
+ ret = phy_resume(hdev->hw.mac.phydev);
+ if (ret)
+ return ret;
+
+ ret = hclge_mac_pause_setup_hw(hdev);
+ if (ret)
+ dev_err(&hdev->pdev->dev,
+ "restore pauseparam error, ret = %d.\n", ret);
+
+ return ret;
+}
+
static void hclge_get_ksettings_an_result(struct hnae3_handle *handle,
u8 *auto_neg, u32 *speed, u8 *duplex)
{
@@ -12943,6 +12972,7 @@ static const struct hnae3_ae_ops hclge_o
.halt_autoneg = hclge_halt_autoneg,
.get_pauseparam = hclge_get_pauseparam,
.set_pauseparam = hclge_set_pauseparam,
+ .restore_pauseparam = hclge_restore_pauseparam,
.set_mtu = hclge_set_mtu,
.reset_queue = hclge_reset_tqp,
.get_stats = hclge_get_stats,
--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.c
@@ -1435,7 +1435,7 @@ static int hclge_bp_setup_hw(struct hclg
return 0;
}

-static int hclge_mac_pause_setup_hw(struct hclge_dev *hdev)
+int hclge_mac_pause_setup_hw(struct hclge_dev *hdev)
{
bool tx_en, rx_en;

--- a/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.h
+++ b/drivers/net/ethernet/hisilicon/hns3/hns3pf/hclge_tm.h
@@ -244,6 +244,7 @@ int hclge_tm_get_pri_weight(struct hclge
int hclge_tm_get_pri_shaper(struct hclge_dev *hdev, u8 pri_id,
enum hclge_opcode_type cmd,
struct hclge_tm_shaper_para *para);
+int hclge_mac_pause_setup_hw(struct hclge_dev *hdev);
int hclge_tm_get_q_to_qs_map(struct hclge_dev *hdev, u16 q_id, u16 *qset_id);
int hclge_tm_get_q_to_tc(struct hclge_dev *hdev, u16 q_id, u8 *tc_id);
int hclge_tm_get_pg_to_pri_map(struct hclge_dev *hdev, u8 pg_id,

\
 
 \ /
  Last update: 2021-11-01 10:51    [W:0.376 / U:0.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site