lkml.org 
[lkml]   [2021]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4] media: rc: pwm-ir-tx: Switch to atomic PWM API
On Thu, Oct 28, 2021 at 08:05:16PM +0200, Uwe Kleine-König wrote:
> On Thu, Oct 28, 2021 at 01:26:10PM +0100, Sean Young wrote:
> > > bloat-o-meter reports (for an arm allmodconfig build)
> > >
> > > add/remove: 0/0 grow/shrink: 3/1 up/down: 644/-396 (248)
> > > Function old new delta
> > > pwm_ir_probe 372 676 +304
> > > pwm_ir_set_carrier 108 292 +184
> > > pwm_ir_set_duty_cycle 68 224 +156
> > > pwm_ir_tx 908 512 -396
> > > Total: Before=2302, After=2550, chg +10.77%
> >
> > So 248 bytes more after your changes.
>
> ack. This is because the compiler inlines the division which accounts
> for > 100 bytes.

I'm surprised it's that large. This is on 32 bit?

> > > struct pwm_ir increases from 12 bytes to 40 bytes.
> > >
> > > The stack space required by pwm_ir_tx decreases from 60 to 36
> > >
> > > I don't know exactly how kmalloc works internally. Maybe allocating a
> > > structure of size 40 bytes doesn't need more memory than a structure of
> > > size 12?
> > >
> > > I didn't check how runtimes change, but the size decrease of pwm_ir_tx()
> > > is nice and might save a bit of runtime.
> >
> > I'm not following, how is this decreasing runtime?
>
> With my changes pwm_ir_tx got smaller and { pwm_ir_probe,
> pwm_ir_set_carrier, pwm_ir_set_duty_cycle } got bigger. Now if for a
> typical runtime pattern pwm_ir_probe and pwm_ir_set_carrier run once and
> pwm_ir_set_duty_cycle 100 times and pwm_ir_tx 1000 times (no idea if
> that is realistic) it might be a net win in sum.

The two most common programs for sending IR are

ir-ctl: https://git.linuxtv.org/v4l-utils.git/tree/utils/ir-ctl/ir-ctl.c#n1041
lircd: https://sourceforge.net/p/lirc/git/ci/master/tree/lib/transmit.c

For each transmission, the carrier is set. If the duty cyle is specified,
then that is set too. Then the transmit itself is done. Both of them
set the carrier and duty cycle (if required) for every transmission: setting
the carrier and duty cycle is a cheap operation, and it is device property
which can be overriden by another process.

This means with your changes, if the carrier and duty cycle are both set
for each transmission, then we're doing more work. If only the carrier
is set for each transmission, then there is no net gain/loss (I think),
but the code size has increased.


Thanks for prototyping this.

Sean

\
 
 \ /
  Last update: 2021-10-29 09:16    [W:0.172 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site