lkml.org 
[lkml]   [2021]   [Oct]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 1/3] KVM: s390: clear kicked_mask before sleeping again
On Wed, 20 Oct 2021 08:08:16 +0200
Claudio Imbrenda <imbrenda@linux.ibm.com> wrote:

> > >> + clear_bit(vcpu->vcpu_idx, vcpu->kvm->arch.gisa_int.kicked_mask);
> > >
> > > so, you unconditionally clear the flag, before knowing if the vCPU is
> > > runnable?

Right. I talked about this with Mimu. It would extend the section
guarded by the bit, and than may be a good thing. Maybe we should
measure that alternative as well.

> > >
> > > from your description I would have expected to only clear the bit if
> > > the vCPU is not runnable.
> > >
> > > would things break if we were to try to kick the vCPU again after
> > > clearing the bit, but before dispatching it?
> >
> > The whole logic is just an optimization to avoid unnecessary wakeups.
> > When the bit is set a wakup might be omitted.
> > I prefer to do an unneeded wakeup over not doing a wakeup so I think
> > over-clearing is safer.
> > In fact, getting rid of this micro-optimization would be a valid
> > alternative.
>
> my only concern was if things would break in case we kick the vCPU
> again after clearing the bit; it seems nothing breaks, so I'm ok with it

I'm not sure about the exact impact of over-waking.
kvm_s390_vcpu_wakeup() sets vcpu->valid_wakeup which is I believe used
for some halt poll heuristics. We unset that in
kvm_arch_vcpu_block_finish(). If we cleared only conditionally the
protection would extend for that as well. Which would be a good thing.
The statistics stuff in kvm_vcpu_wake_up() does account for already
running, so I see no correctness issues there.

Regards,
Halil




\
 
 \ /
  Last update: 2021-10-20 10:15    [W:0.073 / U:0.608 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site