lkml.org 
[lkml]   [2021]   [Oct]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
    Patch in this message
    /
    From
    Subject[PATCH v2 09/24] PCI: histb: Remove redundant error fabrication when device read fails
    Date
    An MMIO read from a PCI device that doesn't exist or doesn't respond
    causes a PCI error. There's no real data to return to satisfy the
    CPU read, so most hardware fabricates ~0 data.

    The host controller drivers sets the error response values (~0) and
    returns an error when faulty hardware read occurs. But the error
    response value (~0) is already being set in PCI_OP_READ and
    PCI_USER_READ_CONFIG whenever a read by host controller driver fails.

    Thus, it's no longer necessary for the host controller drivers to
    fabricate any error response.

    This helps unify PCI error response checking and make error check
    consistent and easier to find.

    Signed-off-by: Naveen Naidu <naveennaidu479@gmail.com>
    ---
    drivers/pci/controller/dwc/pcie-histb.c | 4 +---
    1 file changed, 1 insertion(+), 3 deletions(-)

    diff --git a/drivers/pci/controller/dwc/pcie-histb.c b/drivers/pci/controller/dwc/pcie-histb.c
    index 86f9d16c50d7..410555dccb6d 100644
    --- a/drivers/pci/controller/dwc/pcie-histb.c
    +++ b/drivers/pci/controller/dwc/pcie-histb.c
    @@ -127,10 +127,8 @@ static int histb_pcie_rd_own_conf(struct pci_bus *bus, unsigned int devfn,
    {
    struct dw_pcie *pci = to_dw_pcie_from_pp(bus->sysdata);

    - if (PCI_SLOT(devfn)) {
    - *val = ~0;
    + if (PCI_SLOT(devfn))
    return PCIBIOS_DEVICE_NOT_FOUND;
    - }

    *val = dw_pcie_read_dbi(pci, where, size);
    return PCIBIOS_SUCCESSFUL;
    --
    2.25.1
    \
     
     \ /
      Last update: 2021-10-15 16:45    [W:4.071 / U:0.044 seconds]
    ©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site